Filter
Top Products
Your new cooktop bumers have been preset for an "average" set of conditions. Regional
variances in gas pressure and atmospheric conditions such as height above sea level
may affect your initial flame performance•
When the control knob is turned on, gas enters the mixer tube and mixes with air. This
air and gas mixture flows to the burner head and is lighted by a spark from the solid state
igniter•
A properly adjusted burner with clean ports will light within a few seconds, The cone-
shaped flame will be dear blue in color with a clearly defined inner cone. There should
be no trace of yellow in the flame. A yellow flame indicates an improper mixture of air
and gas. If your flame does not resemble the "correct" flame as described above, follow
the air shutter adjustment instructions below.
The variable surface controls for the surface burners and grill burner provide flexibility
in heat setting selection,
Note: The grill can be replaced with an optional surface burner module, Model AG202.
Surface Burners
In case of prolonged power failure, you can manually light the surface burner by holding
alighted match nearthe burner ports and slowly turning the control knob counterclockwise
(after depressing) until the gas ignites. There is no fan so smoke and condensation can
gather.
Grill
IN CASE OF POWER FAILURE DO NOT USE GRILL• VENTILATION SYSTEM WiLL
NOT OPERATE•
Air Shutter Adjustment
To Adjust Surface Burner Air Shutter (Some models):
Loosen fastening screw with a phillips 8URFACEBURNERROTATEAIR
screwdriver and rotate air shutter to increase A_aSHU_TER SHU_ERON
MJXEF_HEAD TC
or decrease the size ofthe airopening. As the SCREW MAKEA_R
appearance• Adjustrnent is satisfactory when A_RS.U_E,
a clearly defined, even blue flarne results at AIROPENING TO
the Hi flame setting. Afteradjustrnent, tighten A_a_ "_CLOSEOPeNw
screw•
10