Filter
Top Products
4
INSTALLATION
Materials Needed:
•
3
⁄8” hex head driver
• Carpenter’s level.
1. Remove toe grille.
• Grasp firmly and pull outward to unclip.
2. Using hex head driver, turn the front adjustment
screws
(A) on each side to raise or lower the front
of the refrigerator (see illustration below).
3. Using the hex head driver, turn each of these
adjustment screws
(B) to raise or lower the rear of
the refrigerator
.
4.
Using a c
arpenter’s level, make sure front of
refrigerator is
1
⁄4” (6 mm) or approximately
1
⁄2 bubble
higher than back of refrigerator and that the
refrigerator is level from side to side.
5. Turn stabilizing legs
(C) clockwise until firmly
against floor
.
6. Turn adjustment screws
(A) counterclockwise to
allow the full weight of the refrigerator to re
st on
the stabilizing legs.
7. Replace the toe grille.
Leveling
To protect property and refrigerator from
damage, observe the following:
• Protect vinyl or other flooring with cardboard, rugs,
or other protective material.
•
Do not use power tools when performing leveling
procedure.
CAUTION
To enhance the appearance and maintain performance,
t
he refrigerator should be leveled per instructions
below.
Notes:
• Complete any required water supply connection
before leveling.
• Some models only have adjustment screws
(A).
CC
A
B
A
B
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
To avoid electrical shock which can cause
severe personal injury or death, observe the
following:
• Disconnect power to refrigerator before removing
doors or drawer. Connect power only after
replacing doors or drawer.
WARNING
T
o avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard, rugs or other
protective material.
CAUTION
Door and Drawer Removal
S
ome installations require door/drawer removal to
transport the refrigerator to its final location.
Materials Needed:
•
5
⁄1
6
” hex head driver
• Phillips screwdriver
•
3
⁄8” hex head driver
1.
Unplug power cord from power source.
2. Remove toe grille.
3. Remove top hinge cover from
refrigerator door by removing Phillips
screw and r
et
ain screw and cover for
later use.
4. Unscrew
5
⁄16” hex head screws from
top hinge to remove hinge and
r
et
ain all screws for later use.
5. Lift right side refrigerator door from
center hinge pin. Remove door
closure from center hinge pin on
the right side and ret
ain for later
use.
6.
Disconnect wire harne
ss on top
of left side refrigerator door top
hinge.
• Release two-pin connector by
pressing junction point with a
flat blade screwdriver or
fingernail.
• Green ground wire remains
attached to the hinge.
7. Unscrew
5
⁄16” hex head screws from
top hinge to remove hinge and
ret
ain for later use.
right
side
door
closure
12828168 JA FD ENG 3/1/06 7:55 AM Page 5