Filter
Top Products
8
INSTALLATION
5. Slide brass nut over sleeve and screw
nut into inlet port.
Place adjustable wrench on nut
(1) attached to plastic waterline
and maintain position.
Using second adjustable wrench
turn the lower nut
(2)
counterclockwise and fully
tighten while holding the upper
nut in place.
Important: Do not over-tighten.
Cross threading may occur.
6. Pull on tubing to confirm
connection is secure.
Connect tubing to frame
with water tubing clamp
(C)
and turn on water supply.
Check for leaks and correct
if necessary. Continue to
observe the water supply
connection for two to three
hours prior to moving the
refrigerator to its permanent
location.
7. Monitor water connection for 24 hours.
Correct leaks, if necessary.
C
1
2
12828168 JA FD ENG 3/1/06 8:04 AM Page 9