Jenn-Air JDB-5 Dishwasher User Manual


 
2
Before You Start
Don’t prerinse. Simply scrape off any bones or
large food particles.
If connected to a food waste disposer, make certain
the disposer is empty before starting the
dishwasher.
Scrape off tomato-based food soils (see page 15).
Remove certain foods such as mustard,
mayonnaise, lemon juice, vinegar, salt or dressings
from stainless steel flatware as soon as
possible.
These foods may cause rusting and pitting
if allowed to remain in contact with the surface for
an extended period of time.
Operating the Dishwasher
(Models with front or combination front and
top touchpad controls)
1. After loading the dishwasher and adding
detergent, select the desired cycle and options by
pressing the pads. The indicator lights for the
selected c
ycle and options will illuminate. To cancel
an option press the pad again.
2. To start a cycle, close the door until it latches then
press the
START/Cancel pad once. After a pause,
the fill will begin. The display countdown (select
models) will flash until START/Cancel is pressed.
Note
If START/Cancel is not pressed within 30
seconds of choosing your cycle, the dishwasher
will turn off
.
T
o prevent unplanned c
ycle or option change
s,
these selections are “locked in” after 1 minute.
The dishwasher remembers your last cycle so you
do not have to reset the cycle each time. To start
the dishwasher using the same cycle and options
selected on the previous wash, just pre
ss the
S
TART/Cancel
pad.
3. To cancel a running cycle, press the
START/
Cancel pad once. The dishwasher will drain, then
shut off
. To turn the dishwasher off without
draining, press the START/Cancel pad twice.
Note
If a cycle pad is pressed after the controls have
been “locked in”, the light above the current cycle
will flash three times.
Operating the Dishwasher
(Models with top only touchpad controls)
1. After loading the dishwasher and adding
detergent, select the desired cycle and options by
pressing the pads. The indicator lights for the
selected cycle and options will illuminate. To cancel
an option press the pad again.
2. To start a cycle, press the
START/Cancel pad
once. The indicator light will illuminate. Close the
door until it latches. After a pause, the fill will
begin.
Note
If START/Cancel is not pressed within 30
seconds of choosing your cycle, the dishwasher
will turn off
.
To prevent unplanned cycle or option changes,
these selections are “locked in” after 1 minute.
The dishwasher remembers your last cycle so you
do not have to reset the c
ycle each time. T
o start
the dishwasher using the same c
ycle and options
selected on the previous wash, just press the
START/Cancel pad.
3. To cancel a running cycle, carefully unlatch the
door without opening completely and wait for
water circulation to stop. Press the
START/
Cancel pad once and then shut the door. The
dishwasher will drain, then shut off. To turn the
dishwasher off without draining, pre
ss the
S
TART/Cancel
pad twice and then shut the door
.
Note
If a cycle pad is pressed after the controls have
been “locked in”, the light above the current cycle
will flash three time
s.
Cont.
OPERATING TIPS