Filter
Top Products
14
To Convert Surface Burners
1. Remove LP gas orifice hoods. Locate the Natural gas orifice
hoods that were originally installed on the cooktop.
2. To convert from LP gas to Natural gas, apply a ½" open-end
wrench to hex section of orifice hood. Turn counterclockwise
to remove.
3. Replace with correct color-coded orifice hoods (supplied).
See the “Natural Gas Orifice Hood Chart.” Turn clockwise to
install. Screw down the orifice hood so that the outer end of
the orifice hood is ¹¹⁄₁₆" from the face of the mounting spud.
See the following illustration
.
Natural Gas Orifice Hood Chart
4. Place LP gas orifice in plastic parts bag for future use and
keep with package containing literature.
5. Repeat for the remaining burners.
Complete Installation
1. Refer to the “Make Gas Connection” section for properly
connecting the cooktop to the gas supply.
2. Refer to the “Burner Ignition” section for proper burner
ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for
each cooktop burner.
Checking for proper cooktop burner flame is very important.
The cooktop “low” burner flame should be a steady blue
flame approximately ¼" (0.64 cm) high.
3. Refer to the “Complete Installation” section of this manual to
complete this procedure.
A.½" open-end wrench
B.Orifice hood
C.Mounting spud
Turn
clockwise
to tighten
Turn
counterclockwise
to remove
A
B
C
Burner BTU/hr Orifice Diameter
(inches)
Color
Left rear 8,000 #55 .0520 Green
Left front 8,000 #55 .0520 Green
Center rear 10,000 #53 .0595 Brass
Center front 10,000 #53 .0595 Brass
Right rear 10,000 #53 .0595 Brass
Right front 10,000 #53 .0595 Brass