Filter
Top Products
11
Dries dishes with heat. This
option with the use of rinse aid
will provide the best drying
performance. Plastic items are
less likely to deform when loaded
in the top rack. Turn Precision
Dry® off for an air dry.
Available with
any cycle
except
Refresh/Rinse
Activates the
heating element
at the end of the
wash cycle to
speed drying
times. The option
defaults to on
when any cycle is
selected except
for 1 Hour Wash.
44 51 0
Runs the dishwasher at a later
time or during off-peak electrical
hours. Select a wash cycle and
options. Press 4 HOUR DELAY.
Press START/RESUME. Close the
door firmly.
NOTE: Anytime the door is
opened (such as, to add a dish),
the Start/Resume button must be
pressed again to resume the
delay countdown.
Available with
any cycle
except
Refresh/Rinse
Activates the
heating element
at the end of the
wash cycle to
speed drying
times. Precision
Dry® defaults to
ON when any
cycle is selected
except for 1 Hour
Wash.
240 240 0
Control Lock
(on some models)
Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold CONTROL LOCK for 3 seconds. The Control Lock light will stay on for a short time,
indicating that it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked,
the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked.
To turn off Lock, press and hold CONTROL LOCK for 3 seconds. The light turns off.
OPTION SELECTIONS
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED TIME TO
CYCLE
ADDED
WATER
GALLONS
(LITERS)
TYPICAL MAX
CONTROLS AND CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or resume a
wash cycle
If the door is opened during a cycle or power is interrupted, the Start/Resume indicator
flashes. Press START/RESUME and push the door firmly closed within 3 seconds.
NOTE: If the door is not closed within 3 seconds, the Start/Resume indicator will flash, an
audible tone will be heard, and the cycle will not start.
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
Press CANCEL/DRAIN to reset any control selections made.
See “Canceling A Cycle” and “Changing a Cycle After Dishwasher Is Started” sections.