Filter
Top Products
Other Hints on Caring for
Your Oven
Cleaning Other Surfaces of Your Oven
Door and control panel trim: The metal trim around the door and the control panel
can be cleaned with any nonabrasive cleansers such as Ben Ami or soapy water, rinse
well. Be careful not to use an excessive amount of water.
Glass on the oven door front: To clean, use any suitable glass cleaner or soapy
water. To prevent moisture from getting behind the glass control panel, spray a cloth
with glass cleaner then wipe the panel.
Control Knob: Control knob can be removed for cleaning. Wash in warm soapy water.
Match the "D" shaped hole in the knob to the "D" shaft when replacing.
Control Panel: Wipe with a damp cloth. Dry thoroughly. Do not use cleaning sprays,
large amounts of soap and water, abrasives, or sharp objects on the panel. They can
damage it.
Oven Racks .,,
To remove pull forward to the "stop" position; _'_ O_
lift up on the front of the rack and pull out.
Oven Light Bulb
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker panel.
Be sure that the entire oven cavity including the light bulb is cool before attempting to
remove.
To replace light bulb:
1. Carefully unscrew the glass light lens.
2. To obtain firm grasp on bulb, wear protective rubber
gloves. Remove by turning bulb to the left. Do not touch J
a hot oven light bulb with a damp cloth as bulb will break.
NOTE: If the bulb does break and you wish to remove it,
be certain power supply is disconnected and wear protec-
tive gloves. You may contact your authorized Jenn-Air
Service Contractor for service.
3. Replace bulb with a 40 watt oven-rated appliance bulb.
Bulb with brass base is recommended to prevent fusing of
bulb into socket.
4. Replace bulb cover and reconnect power to oven. Reset
clock.
24