Filter
Top Products
Door and control panel trim
The metal trim around the door and the control panel can be cleaned witha household
cleaner orsoapy water, rinsewell. Be careful not to use an excessive amount of water.
Glass on the oven door front
use any suitable glass cteaner or soapy water.
Control Panel Area end Display Window
Wipe with paper towels dampened with soapy water orglasscleaner. Do notspray any
cleaning solutions directly onto the Display window or use large amounts of soap and
water. Do not scrub with S.O.S. pads or abrasive cleaners.
To remove pull forward to the "stop" position; lift up
on the front of the rack and pull out. \
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker
pane/. Be sure thatthe entire oven cavity includingthe lightbulb iscool before attempting
to remove.
To replace light bulb ]
1. Carefully unscrew the glass light lens. j
/
2. To obtain firm grasp on the bulb, wear protective rubber
gloves. Remove byturning bulb to the left. Do not touch a
hot oven light bulb with a damp cloth as bulb willbreak. Note: f_._ _
Ifthe bulb does break and you wish to remove it, be certain
Y
power supply is disconnected and wear protective gloves.
You maycontact yourauthorized Jenn-Air Service Contractor
for service.
3. Replace bulb with a40 watt oven-rated appliance bulb. Bulb
with brass base is recommended to prevent fusing of bulb
into socket.
4. Replace bulb cover and reconnect power to oven. Reset
clock.
31