Filter
Top Products
10
Place guide (Ha) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes.After having drilled
holes, fix the guide with the screws supplied.
Fix cover (Hc) on guide (Ha) until it clips into place
PR33
Hc
Ha
PR167
Ha
Hb
8mm
Open the appliance door and the furniture door at
90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure.
Remove the squares and drill holes with ø 2 mm at
8 mm from the outer edge of the door. Place the
small square on the guide again and fix it with the
screws supplied.
PR266
Ha
Hb
Hc
Hd
Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
Apply covers (C-D) on joint cover lugs and into
hinge holes.
Snap vent grille (B) and hinge cover (E) into
position.
B
E
C
D
2
1
m
m
ca. 50 mm
90°
ca. 50 mm
2
1
m
m
PR168
Hb
Should the lining up of the furniture door be
necessary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
11
After completion of the door reversing
operation, check that the door gasket
adheres to the cabinet. If the ambient
temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the
gasket or accelerate this process by heating
up the part involved with a normal hairdryer
on a low setting.
PR167/1
Hd
Hb
Fix cover (Hd) on guide (Hb) until it clips into place.