Filter
Top Products
Warning
IF YOU ARE DISCARDING AN OLD APPLIANCE
THAT HAS A LOCK OR CATCH ON THE DOOR,
YOU MUST ENSURE THAT IT IS MADE
UNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.
Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens.To do this, refer to
instructions on “Door reversal directions”.
Positioning
This appliance should only be installed at a location
where the ambient temperature corresponds to the
climate classification indicated on the rating plate,
which is located at the left on the inside of the
appliance.
The following table shows which ambient
temperature is correct for each climate
classification:
SN +10°C to + 32°C
N +16°C to + 32°C
ST +18°C to + 38°C
T +18°C to + 43°C
It should be located in a dry atmosphere, out of
direct sunlight and away from extreme temperature
e.g. not next to a boiler or radiator, or in a very cold
room e.g. an outhouse . If these temperatures are
exceeded i.e. colder or warmer, then the appliance
may not operate correctly.
For building-in and door reversibility, if necessary ,
refer to the relevant instructions in the following
pages.
Important
It m
ust be possible to disconnect the appliance from the
mains power supply; the plug must therefore be easily
accessible after installation.
7
The appliance should be left for 2 hours after
installation before it is turned on, in order to allow
the refrigerant to settle.
Shelf holders
Your appliance is equipped with shelf retainers that
make it possible to secure the shelves during
transportation.
To remove them proceed as follows:
Move the shelf holders in the direction of the
arrow, raise the shelf from the rear and push it
forward until it is freed and remove the retainers.
A
C
B
14
Movable shelves
The walls of the refrigerator have runners so that
the shelves can be positioned as desired .
For better use of space, the front half-shelves can lie
over the rear ones.
Positioning the door shelves
To permit storage of food packages of various sizes,
the door shelves can be adjusted in height.To make
these adjustments proceed as follows:
Gradually pull the shelf in the direction of the
arrows until it comes off, then reposition as
required.
D338
Bottle holder
Place the bottles (with the opening facing front) in
the pre-positioned shelf.
If the shelf is positioned horizontally, place only
closed bottles.
This bottle holder shelf can be tilted in order to
store previously opened bottles.
To obtain this result, pull the shelf up so it can
rotate upwards and be placed on the next higher
level.