Filter
Top Products
11
“End of cooking” function“End of cooking” function
“End of cooking” function“End of cooking” function
“End of cooking” function
With this function, you can set the oven to switch off automatically when a
programmed end of cooking time is over. Place food in the oven, select a cooking
function and adjust the cooking temperature. Press “Time functions” button
repeatedly to select the “End of cooking” function. The relevant pilot lamp will
start flashing (Fig. 4). Then, proceed as follows:
To set the End of cooking time:To set the End of cooking time:
To set the End of cooking time:To set the End of cooking time:
To set the End of cooking time:
1.1.
1.1.
1 . Press button “ ” or “ ” (Fig. 5).
2.2.
2.2.
2 . After the setting is carried out, wait for 5 seconds: the “End of cooking” pilot
lamp will come on and the display will revert to the time of day.
3.3.
3.3.
3 . When cooking time is over, the oven will be switched off automatically and an
acoustic alarm will be heard, while the pilot lamp will start flashing. Turn the
oven function and the thermostat control knob to zero.
To switch off the acoustic alarm, press any button.
NONO
NONO
NO
TE:TE:
TE:TE:
TE: Turning the acoustic alarm off will reset the oven to manual, and if the
oven function and the thermostat knobs are not set to zero the oven will start
to heat again.
To cancel the End of cooking time:To cancel the End of cooking time:
To cancel the End of cooking time:To cancel the End of cooking time:
To cancel the End of cooking time:
1.1.
1.1.
1 . Press “Time functions” button
repeatedly to select the “End of cooking”
function. The relevant pilot lamp will flash and the display will show the
programmed end of cooking time.
2.2.
2.2.
2 . Press button “ ” until the display shows the current time of day. The
programmer will beep and the pilot lamp will go out.
“Cooking duration”“Cooking duration”
“Cooking duration”“Cooking duration”
“Cooking duration”
andand
andand
and
“End of cooking“End of cooking
“End of cooking“End of cooking
“End of cooking
time” combinedtime” combined
time” combinedtime” combined
time” combined
The functions “Cooking duration” and “End of cooking time” can be used
simultaneously to set the oven to switch on and off automatically at a later time
(Fig. 6).
1.1.
1.1.
1 . With the “Cooking duration” function (carry out the cooking duration setting
as described in the relevant chapter) set the duration time. Then, press “Time
functions” button: the display will show the programmed setting.
2.2.
2.2.
2 . With the “End of cooking time” function (carry out the end of cooking setting
as described in the relevant chapter) set the end of cooking time.
The relevant pilot lamps will come on and the display will show the time of
day. The oven will switch on and off according to the set programmes.
“Minute timer” function“Minute timer” function
“Minute timer” function“Minute timer” function
“Minute timer” function
The minute timer alarm will sound at the end of a timed period, but THE OVEN
WILL REMAIN ON, if it is in use.
To set the minute timer :To set the minute timer :
To set the minute timer :To set the minute timer :
To set the minute timer :
1.1.
1.1.
1 . Press “Time functions” button
repeatedly to select the “Minute timer” function.
The relevant pilot lamp will start flashing.
2.2.
2.2.
2 . Then, press button “ ” or “ ” (maximum: 2 hours, 30 minutes - Fig. 7).
3.3.
3.3.
3 . After the setting is carried out, wait for 5 seconds: the “Minute timer” pilot
lamp will come on.
4.4.
4.4.
4 . At the end of the timed period, the pilot lamp will start flashing and an
acoustic alarm will be heard. To switch off the acoustic alarm, press any button.
To cancel the minute timer:To cancel the minute timer:
To cancel the minute timer:To cancel the minute timer:
To cancel the minute timer:
1.1.
1.1.
1 . Press “Time functions” button repeatedly to select the “Minute timer” function.
The relevant pilot lamp will flash and the display will show the remaining
time.
2.2.
2.2.
2 . Press button “ ” until the display shows “0:00”. After 5 seconds the pilot
lamp will go out and the display will revert to the time of day.
HoHo
HoHo
Ho
w to sw to s
w to sw to s
w to s
witch off the displawitch off the displa
witch off the displawitch off the displa
witch off the displa
yy
yy
y
1.1.
1.1.
1 . Press two or three programmer push buttons simultaneously and keep them
pressed for about 5 seconds (Fig. 8). The display will switch off.
2.2.
2.2.
2 . To switch on the display, press any button.
The displaThe displa
The displaThe displa
The displa
y can be sy can be s
y can be sy can be s
y can be s
witched off onlwitched off onl
witched off onlwitched off onl
witched off onl
y if no other functions hay if no other functions ha
y if no other functions hay if no other functions ha
y if no other functions ha
vv
vv
v
ee
ee
e
been set.been set.
been set.been set.
been set.
Fig. 4Fig. 4
Fig. 4Fig. 4
Fig. 4
Fig. 5Fig. 5
Fig. 5Fig. 5
Fig. 5
Fig. 6Fig. 6
Fig. 6Fig. 6
Fig. 6
Fig. 7Fig. 7
Fig. 7Fig. 7
Fig. 7
Fig. 8Fig. 8
Fig. 8Fig. 8
Fig. 8