Filter
Top Products
49
Putting the door glass panels back.
1.
From above insert the door glass panels one
after the other into the door profile at the
bottom edge of the door at an angle and
lower them.
3
The two smaller panels first, then the
larger panel.
2.
Take hold of the door trim (B) at each side,
position it on the inside edge of the door
and plug the door trim (B) into the upper
edge of the door.
3
On the open side of the door trim (B)
there is a guide bar (C). This must be
pushed
between
the outer door panel
and the guide corner (D).
The clip seal (E) must be snapped in.
3.
Open the oven door as far as it will go.