Filter
Top Products
Frost precautions
Avoid placing the machine in a location where
the temperature is below 0°C. If this is
unavoidable, empty the machine, close the
appliance door, disconnect the water inlet
pipe and empty it.
Moving the machine
If you have to move the machine (moving
house, etc...):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge
hoses.
4. Pull the machine out together with the
hoses.
Avoid over tilting the machine during
transportation.
Something not working
The dishwasher will not start or stops during
operation.
Certain problems are due to the lack of simple
maintenance or oversights, which can be
solved with the help of the indications
described in the chart, without calling out an
engineer.
Switch off the appliance and carry out the
following suggested corrective actions.
Important! If you call out an engineer to a
fault listed below, or to repair a fault caused
by incorrect use or installation, a charge will
be made even if the appliance is under
guarantee.
Fault code and malfunction Possible cause and solution
•
intermittent audible signal is active
1)
•
appears in the digital display
•
message OPEN THE TAP
displayed
The dishwasher does not fill with
water
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fitting at
the water inlet valve is blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly laid or it is
bent or squashed.
Check the water inlet hose connection.
•
intermittent audible signal is active
1)
•
appears in the digital display
•
message DRAIN BLOCKED
displayed
The dishwasher will not drain
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid or it is
bent or squashed.
Check the water drain hose connection.
24