Filter
Top Products
6a. FILLING THE WATER TANK
Please note: Only use fresh, cold water. Never fill water tank
with carbonated water, milk or any other liquid.
• Remove the water tank, rinse and fill with fresh, cold water.
• Replace water tank and make sure that it engages securely.
6b. FILLING THE BEAN CONTAINER
Please note: To ensure that the conical burr grinder continues to
function properly, please avoid using any kind of coated or
flavored beans (all coating and flavors contain sugar or sugar
substances). Such coating can damage the burrs. Using such
beans voids the warranty. Have your coffee store grind the sugar
coated beans and use as described in chapter 9d.
Flavored Coffee: If you like flavored coffees we recommend
adding flavors to your coffee after brewing. This way you can
use your regular coffee beans in the bean container. Adding the
flavors after brewing lets you control the flavor intensity much
better than with pre-flavored coffee. Your local coffee store
typically carries a variety of liquid flavors.
• Open the lid for the bean container and remove the Aroma
Protection Lid.
• Make sure the bean container is empty and clean. Fill beans
into the bean container (Fig. 5).
Frozen Beans: Thaw 3 to 4 hours before adding to bean
container. This prevents moisture from seeping into the grinder.
Oily Beans: Beans with an oily surface tend to stick together.
This may prevent a continuous flow of beans from the bean
container into the burrs. As a result the grinder does not grind
enough coffee and you might get weak or no coffee at all.
Stir the beans in the bean container just before grinding.
Alternatively, you can also pour the beans into an open bowl and
let them sit for about 5 hours. The oils will evaporate (this will
not change the taste of your coffee). Then fill the beans into the
bean grinder. Now beans will feed into the burrs more easily.
6c. TURNING THE MACHINE ON FOR THE FIRST TIME
• Make sure bean container and water tank are filled.
• Press the Main Power Switch in the back of the machine (Fig. 1a)
A red light in the left round button cluster illuminates (Fig. 3.4).
• Push the On/Off button (Fig . 3.1). The display shows
PRESS
RINSE
and the Rinse button (Fig. 3.2) illuminates.
• Place a cup underneath the Auto Cappuccino System
(Fig. 17) and push the Rinse button (Fig. 3.2). SYSTEM FILLING.
The machine dispenses a small amount of water.
HEATING
then PRESS RINSE.
• Place cup underneath the dual coffee spout (Fig. 17) and press
the Rinse button (Fig. 3.2). RINSING. The machine dispenses
a small amount of water.
READY.
Please note: You can only make coffee when the display reads
READY.
• Place a cup under the coffee spout and push one of the coffee
buttons. The machine will grind and brew coffee. If the display
shows
FILL BEANS push one of the coffee buttons again.
• Discard the first two cups of coffee.
You are now ready to brew coffee.
7. ADJUSTING THE GRINDER
IMPORTANT: The grinde can only be adjusted while the grinder
is actually grinding.
Adjust the grinder to the roast of your coffee.
13.