Jura Capresso C9 Coffeemaker User Manual


 
15.4 EMPTYING THE SYSTEM BEFORE TRANSPORT
This procedure is necessary to prevent water and frost damage
in case you intend to transport the machine.
READY.
Remove the frothXpress system and place a container under
the steam nozzle (Fig. 18).
Push the Milk button HEATING.
When the display shows
READY again, push the Milk button
again. The display shows MILK and steam starts to come out
of the steam nozzle.
Now remove the water tank and empty it. Steam is discharged
until the display shows
PRESS RINSE.
Turn the C9 OT off and turn the main power switch off.
The next time the machine is turned on, the display shows
PRESS RINSE. Proceed as explained in chapter 6c.
16. AUTOMATIC CLEANING CYCLES
16.1 CLEANING WITH SPECIAL TABLET
The machine monitors how many coffees are brewed and how
often the rinsing program is activated. After approx. 200 coffees
the display shows
READY / CLEAN. You can continue brewing
coffee, however we highly recommend that you clean the machine
as described below within the next few days. This cleaning program
will remove coffee oil build-ups in the brewing chamber. This
cleaning program takes less than 20 minutes. Please use the
enclosed white cleaning tablet. The machine comes with a pack
of 2 tablets. To re-order see chapter 20.
Important: Once the cleaning program has started do not
interrupt the procedure.
READY / CLEAN
1. Push the Rinse Button EMPTY TRAY.
2. Remove and empty the tray and the used coffee container
and replace.
Attention: If the tray and the used coffee container are
already empty, you still need to remove the tray for approx.
20 seconds and then replace it. PRESS RINSE. The Rinse
button illuminates.
3. Place containers (10 oz.) under the coffee spout and the
frothXpress (Fig. 17) and push the Rinse button (Fig. 3.2).
The display shows
CLEANING. After a short while the display
shows
ADD TABLET.
4. Open the ground coffee funnel lid and drop one white tablet
into the opening (Fig. 23). Close lid.
5. Push the Rinse button. The display shows
CLEANING. The
machine will start the automatic cleaning program by
dispensing water in intervals into the containers underneath
the spouts. When finished, the display shows
EMPTY TRAY.
6. Remove the tray. There will be water in the tray and in the
used coffee container. Empty, clean and replace
READY.
16.2 MANUAL TABLET CLEANING
This program is useful if the brewing process slows down due to
excessive oil build-up inside the machine
READY.
Push and hold the Rotary Dial RINSE.
Push the Rotary Dial, display shows C CLEANING.
Turn the dial until the display shows
CLEAN and push the
dial. The display shows EMPTY TRAY.
Continue with the steps 2 through 6 from the chapter 16.1.
27.