Jura Capresso C9 Coffeemaker User Manual


 
17. DECALCIFYING
The machine has an integrated decalcifying program. This
program takes 45 minutes. When the display shows
READY /
DE-SCALE it is time to decalcify the machine. The Rinse button
is illuminated. You can still make coffee. It is recommended to
decalcify the machine within the next 3 to 4 days.
Please note: If you use the Clearyl water cartridge and the
display shows READY / DE-SCALE your cartridge function was
not activated. Follow the instructions in chapter 13a to activate
the Clearyl cartridge. If the cartridge is in use for several weeks
install a new cartridge.
Important: The decalcifying program must not be interrupted.
NOTE: Only use our special, square decalcifying tablets
Model # 66281, see chapter 20.
CAUTION: Never use vinegar or any other decalcifying agent.
This might damage internal parts of the machine.
CAUTION: Immediately remove any splashes of the decalcifying
solution from sensitive surfaces, such as natural stone or wood.
CAUTION: If the decalcifying solution comes in contact with the
skin, rinse it off with water. If the solution comes in contact with
your eyes, see a doctor.
Important: Always wait until the decalcifying solution in the
water tank has been used up. Do not fill additional decalcifying
solution into the water tank.
17.1 DECALCIFYING PROCEDURE
1. Push the Rinse button, display shows EMPTY TRAY.
2. Remove and empty the tray and the used coffee container
and replace, display shows
AGENT IN TANK.
Attention: If the tray and the used coffee container are
empty, you must remove the tray for approx. 20 seconds
and then replace it.
3. Remove the frothXpress system from the Auto Cappuccino
system.
4. Remove the water container and empty.
5. Completely dissolve 3 of the large square decalcifying
tablets in a container with 18 oz. of water (0.5 liters) and
pour the solution into the water tank.
6. Replace water tank.
AGENT IN TANK. The Rinse button
illuminates.
7. Place a large container under the Auto Cappuccino system
(Fig. 18).
8. Push the Rinse button. The display shows
DE-SCALING and
the light in the Rinse button flashes during the operation.
The machine pumps the decalcifying solution in intervals
through the Cappuccino system.
9. When display shows
EMPTY TRAY, remove and empty the
container. Then carefully remove and empty the tray and
the used coffee container and replace.
10. Display shows
FILL WATER TANK. Remove the water tank,
rinse thoroughly, fill it halfway with fresh water and replace.
The display shows
PRESS RINSE.
11. Place the container under the Auto Cappuccino system and
push the Rinse button DE-SCALING.
12. The machine pumps fresh water through the system and
stops automatically. The display shows
EMPTY TRAY.
13. Remove and empty the container. Then carefully remove
and empty the tray and the used coffee container and
replace.
READY.
14. Attach the frothXpress system to the steam nozzle.
28.