Jura Capresso E65 Coffee Grinder User Manual


 
13
11.7 Insert filter
Pull up the cartridge holder in the water tank. Pressing gently,
put the filter cartridge into the water tank (Fig. 4).
Close the cartridge holder until it engages audibly.
Fill the water tank with cold fresh tap water and put it back into
the machine.
Switch the machine off with the ON/OFF switch.
Press the draw-off key for about 3 seconds. The degree of
hardness set appears on the display.
Press the draw-off key until only the symbol is still
alight.
Press the ON/OFF switch as a confirmation. The ,
symbols light up.
Place a sufficiently large vessel under the pivoting nozzle for hot
water/steam (13) and turn the selector switch for hot water/
steam (12) to the position .
Draw off water until the symbol lights up.
Now turn the selector switch for hot water/steam (12) back to the
position .
When the symbol lights up, press the maintenance key (4).
Your machine rinses and is ready for drawing off coffee.
The water can be slightly discoloured (not dangerous to
health)
11.8 Replace filter
After 50 litres have been drawn off, the filter loses its effect.
The symbol flashes to inform you.
If you do not draw off often, you should replace the filter
cartridge every 2 months, but no report appears on the dis-
play. There is a special disk on the cartridge holder so that
you can set the replacement date.
Switch your machine off with the ON/OFF switch.
Press the maintenance key (4) for about 3 seconds. The ,
symbols light up.
Empty the water tank and lift up the cartridge mounting.
Pressing gently, put the new filter cartridge into the water tank
(Fig. 4)
Place a sufficiently large vessel under the pivoting nozzle for
hot/water steam (13) and turn the selector switch for hot
water/steam (12) to the position . The symbol flashes.
Draw off water until the symbol lights up.
Now turn the selector switch for hot water/steam (12) back to the
position .
When the symbol lights up, press the maintenance key (4).
Your machine rinses and is ready for drawing off coffee.
11.9 General cleaning instructions
Never use abrasive articles or corrosive chemicals to clean your
machine.
Wipe down the casing on the inside and out using a soft, damp
cloth.
Clean the pivoting nozzle for hot water/steam after each use.
After heating milk, draw off a little hot water in order to clean
the inside of the pivoting nozzle.
You can take off the frothing aid for a thorough cleaning
(Fig. 8).
The water tank should be rinsed out and filled with clean water
every day.
If there is scale visible in the water tank, you can remove it
with a customary de-scaling agent. Remove the water tank
from the machine for this purpose.
E