Jura Capresso E65 Coffee Grinder User Manual


 
7
2. Safety instructions
2.1 Warnings
Children are unaware of the dangers that electrical machines can
represent; for this reason, children should never be left unsuper-
vised with electrical machines.
This machine should only be used by people who have read
these instructions.
Never use a faulty machine or one with a damaged power cable.
Never immerse the machine in water.
2.2 Safety precautions
Never subject the machine to the effects of the weather (rain,
snow, frost) and never operate it with wet hands.
Place your machine on a solid level surface. Never leave it on a
surface which is warm or hot (hob etc.). Choose a location which
is inaccessible for children or for pets.
Always pull the plug out if you are away for a long time (holi-
days etc.).
Always pull the plug out first before cleaning.
When pulling the plug out, never tug on the cord or on the
machine itself.
Never repair or open the machine yourself. All repairs should be
done by authorised service centres only using original Jura spare
parts and accessories.
The machine is connected to the mains power socket via an
electric cable. Make sure that nobody trips over it and pulls the
machine down. Keep children and pets well away from the
machine.
Never put the machine or even parts of it into the dishwasher.
Choose a place with a good circulation of air in order to prevent
the machine from overheating.
If you use de-scaling agents containing acid, remove any splas-
hes and drips on sensitive surfaces, in particular natural stone
and timber surfaces and/or take corresponding precautionary
measures.
3. Preparation of the machine
3.1 Checking the mains voltage
The machine is set to the correct voltage before leaving our
factory. Ensure that your mains voltage corresponds to the details
quoted on the rating plate attached to the bottom of the machine.
3.2 Checking the fuse
The machine is designed for a current of 10 Amps. Check that the
fuse used matches this.
3.3 Filling the water tank
Remove the water tank and rinse it out well with cold tap water.
Then fill the water tank and put it back into the machine. Ensure
that the tank engages properly (Fig. 1).
Only use fresh, cold water. Never fill with milk, mineral
water or other fluids. You can also add water without
removing the tank. Simply lift the lid up and pour in water
from above with a vessel. Close the lid again.
3.4 Adding coffee beans
To ensure that your machine will work perfectly for a long
time and to avoid damage, please note that the grinding gear
of your Jura coffee machine is not suitable for coffee beans
which were treated, during or after roasting, with additives
(e.g. sugar). Such coffee blends may damage the grinding
gear. Any repair costs resulting from the use of such blends
are not covered by warranty.
E