Kambrook KBL180 Blender User Manual


 
7
Using Your Kambrook Blender
Before First Use
Remove and safely discard any
packaging material and
promotional labels.
Disassemble the blender jug
by following the steps in the
‘Disassembling the Blender’
section below. Wash the lid,
inner cap, blender jug, silicone
seal and Removable Blade Holder
in warm, soapy water with a soft
cloth. Rinse and dry thoroughly.
Wipe the motor base with a damp
cloth and dry thoroughly.
Disassembling the Blender
1. Place the motor base on a flat,
dry surface such as a bench top.
Ensure that the Speed Control
Dial is in the ‘OFF’ position, the
appliance is switched off at the
power outlet and the power
cord is unplugged.
2. Hold the base with one hand
and with the other hand turn
the blender jug handle anti-
clockwise and in the opposite
direction of the ‘
’ symbol
on the motor base.
3. Remove the lid and inner cap
from the blender jug.
4. Place the jug upside down on
a flat, dry surface such as a
bench top.
5. Using the inner cap, insert the
two tabs on the inner cap into
the Removable Blade Holder
(See Fig. 1).
Fig. 1
6. Use one hand to hold the jug
handle and the other hand to
turn the inner cap clockwise
to ‘
’ the Removable
Blade Holder (See. Fig. 2).
Fig. 2
7. Once loose, tilt the Removable
Blade Holder at an angle and lift
it up and out of the jug.
WARNING: Blades must
be handled carefully as
they are sharp!