Filter
Top Products
13
INSTALLING GREASE FILTERS
Rest rear fi lters edge on fi lter springs (A) in the range hood.
Using metal latch tab, tilt up the fi lters into position. Make sure
fi lter tabs (B) are securely engaged in range hood front edge
after installation.
HD0393
A
B
HO0140
UPPER FLUE MOUNTING BRACKET
FRONT VIEW
UPPER
FLUE
3. Slide up the upper fl ue until it is aligned with its mounting
bracket. The bracket must be inside the flue. Secure
the upper fl ue to its bracket using 2 no. 8 x 3/8” screws
(included). See illustration beside.
NOTE
Duct not shown in illustration to ease understanding.
4. Remove protective plastic fi lm covering the upper fl ue.
FINALIZE THE INSTALLATION
This range hood must use 2 shielded halogen lamps (120 V, 50 W PAR16 with GU10 base), included.
Refer to page 4 for ordering information.
WARNING: In order to prevent the risk of personal injury, do not install a lamp identifi ed for use only in enclosed
fi xtures.
!
WARNING: In order to prevent the risk of personal injury, the halogen lamps must cool down before removing
them.
!
1. To remove lamps, gently push upwards and turn
counterclockwise to disengage bulb leads from their
grooves.
2. Install the new lamps by placing the bulb leads into their
grooves in the socket.
3. Gently push upwards and turn clockwise until secure.
12 3
HO0089
NOTE
If need be, use a rubber dishwashing glove to add grip when
removing the bulb.
CHANGING LIGHT BULBS
Warranty Safety CleaningOperation Installation Service Parts