Filter
Top Products
Keg
j. Support
REPLACING EMPTY KEG
Close shutoff valve on CO2 regulator then remove keg tappel
from empty keg. To tap a new keg, follow the procedures C, D
and E of "Installing Keg Tapper and Beer Keg."
Cabinet
Bottom
(1) Lift to upright
i
/
/
I
/
(2) Slide into cabinet.
Fig. 3
OPERATION
Place drip tray under beer faucet. To dispense beer, open beer
faucet quickly all the way. If you have any trouble with beer, refer to
"Draught Beer Facts" book.
The recommended pressure for the CO2 system is 8-10 Ibs.
CLEANING
1. To maintain good-tasting beer, periodical cleaning of beer
system is required. Complete cleaning kit is provided for
your convenience. Refer to the instructions included in
cleaning kit.
2. To clean cabinet inside and outside, mix 2 tablespoons baking
soda with 1 quarter warm water, or use mild soap. Never use
strong cleanser, scouring powder or pads.
Do not put the drip tray in dishwasher, it is not dishwasher safe.
Vacuum the tubing on outside back twice a year.
To provide protective care of the painted finish:
Regular applications of wax or polish provide vital protection against
rust. Waxing cleans the surface and seals out moisture and other
contaminants.
Use a wax or polish that is suitable for appliances.
Apply the wax or polish when the refrigerator is new and then at
least twice a year.
Between waxings, clean the cabinet with the same polish or
with a CLEAN soft cloth dampened with a mild household de-
tergent. Rinse with a CLEAN lightly dampened cloth and DRY
thoroughly.