Filter
Top Products
12
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
Step 5 - Install RO Faucet
SELECT LOCATION OF REVERSE OSMOSIS
FAUCET MOUNTING HOLE
You will need to select the location of the Reverse
Osmosis Faucet. You have three options to choose from:
• Use the existing sink top hole for the spray hose or
soap dispenser (Must be 1-1/4” in diameter)
• Drill a new hole in the sink
• Drill a new hole in the countertop next to the sink
1. Determine where you are going to install your Reverse
Osmosis Faucet.
2. Check to ensure the Reverse Osmosis faucet will
mount flat against the mounting surface.
3. Visually review the routing of the tubes from the
Reverse Osmosis filter assembly to the faucet. Check
to ensure there is adequate tube routing space
between the faucet and filter assembly.
4. If drilling is needed, drill a 1-1/4" diameter hole in the
mounting surface.
IMPORTANT: Drilling holes into countertops and
sinks should only be performed by a qualified installer
who is certified for drilling such materials. Drilling of
surfaces made of stone or solid surface materials such
as granite, marble, Coriant or other plastic resin
products or sinks made of porcelain and stainless steel
may cause permanent, irreparable damage to the sink
or countertop surface.