Filter
Top Products
13
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
Step 5 - Install RO Faucet
Figure 14
Figure 15
5. Locate the 1/4" red tubing. One end is connected to the
RO Filter assembly. See Figure 21. Locate the loose
end.
A. Route red tube through countertop to faucet.
B. Cut the loose end of the red tube square and to
length. See Figure 21.
NOTE: Tubing lengths should allow for the removal of
the assembly from the hanger washers for servicing. If
tubing lengths are shortened for neater appearance, it
may be necessary to keep the assembly on the hanger
washers for service.
C. Insert all the way onto the 1/4" faucet barb fitting on
faucet. See Figure 15.
D. Pull on the tubing to be sure it is held firmly in the
fitting.
NOTE: If you ran the red reverse osmosis drain tubing
directly to a remote drain point, disregard step 3 and
refer to instructions on page 10.
6. Mount the faucet body on to the faucet ba
se, 1/4 turn.
FAUCET ELECTRONICS
Inside the faucet base is a battery operated 6 month
timer. See Figure 14.
An amber LED indicator is also located in the front of
the faucet base. This LED will flash continuously after 6
months has passed. This indicates that it is time to
replace the battery, prefilter and postfilter.
INSTALL BATTERY
To install battery, complete the following steps.
1. Loosen the screw on the right side of the faucet base.
See Figure 14.
2. Press the battery housing upwards from the front
faucet base until it releases from the faucet base. See
Figure 14.
3. Replace the battery (CR 2032 or equivalent). Place the
positive (+) side down into the holder.
4. When the battery is first replaced it will flash six times
and turn off. This indicates the battery is fully
charged. After the six flashes the timer enters the 6
month time cycle. If it repeatedly flashes just two
times, it is not a fully charged battery and will need to
be replaced.
5. Re-install the timer housing and firmly tighten the
mounting screw. See Figure 14.
faucet body
faucet base
faucet base
screw
BLACK TUBE
3/8” barb fitting
for the black tube
RED TUBE
1/4” barb fitting
for the red tube
BLUE TUBE
3/8” quick connect
fitting for the blue tube
battery, negative
(-) side facing out
rubber gasket
toggle bolts
battery housing
timer housing
amber LED
screw holding
the battery
housing in place