Kenmore 625.38461 Water Dispenser User Manual


 
6
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
Step 1 - Install Water Supply Fitting
Locate the cold water line in the sink cabinet. Check and
comply with local plumbing codes as you plan, and then
install a water supply fitting on the sink’s cold water line.
The fitting must provide a leak-tight connection to the
Two-Stage Drinking Water Filter’s 3/8” O.D. inlet tubing.
A typical connection using the included water supply fit-
ting is shown in Fig. 3. An alternative connection using
standard plumbing fittings (not included) is shown in
Fig. 4.
Figure 4
NOTE: Local code may dictate which type of water fit-
ting is used. Consult a plumber if you are not familiar
with local codes or plumbing procedures.
NOTE: Codes in the state of Massachusetts require
installation by a licensed plumber.
If you live in the state of Massachusetts, review plumb-
ing code 248-CMR of the Commonwealth of
Massachusetts before proceeding with the installation.
A. WATER SUPPLY CONNECTION
USING INCLUDED FITTING
1. Close the house main water shutoff valve and open
faucets to drain water from the sink’s cold water pipe.
2. Remove the nut that connects the cold water faucet to
cold water plumbing.
3. Thread the included water supply fitting onto the pipe
and reconnect nut to bottom of fitting.
CHOOSE TYPE OF WATER SUPPLY FITTING TO INSTALL
B. WATER SUPPLY TYPICAL CONNECTION
USING COMPRESSION TYPE FITTING
(PARTS NOT INCLUDED)
NOTE: Before starting, be sure to turn off water supply
and open a low faucet to drain the pipe.
Complying with plumbing codes, install a fitting on the
cold water pipe to adapt to 3/8” O.D. tubing. A typical
connection is shown in Figure 4 If threaded fittings are
used, be sure to use pipe joint compound or Teflon tape
on outside threads.
Figure 3
included water
supply fitting
3/8” O.D. yellow
tubing to Water
Filter inlet
cold water
faucet stud
cold water
pipe
cold water
shutoff valve
OR
cold water
pipe
3/8” compression
fitting
insert
ferrule
3/8” yellow
tubing to
Water Filter inlet
cold water
shutoff valve
wrap outside
threads with
Teflon tape