Filter
Top Products
Setting Oven Controls
Using and Setting Meat Probe
To use the meat probe:
1. Prepare the food and properly insert the temperature probe into the food. DO NOT PREHEAT or start cooking
before properly inserting the meat probe, The probe should be inserted into the food and receptacle while the oven
is still cool.
2. Place the prepared food on the desired oven rack position and slide into the oven.
3. Plug the meat probe into the probe receptacle located on the left front oven cavity side.
4. Close the oven door.
5. The oven control will detect if the meat probe is correctly plugged in and will illuminate with ,,It icon in the display.
6. The actual meat probe temperature will appear in the display.
7. To set the target temperature press @ pad once then enter the desired the desired target internal
temperature
using the numeric key pads (default setting is 170°F/77°C)f. Press _ to accept the meat probe target
temperature.
8. Set the oven control for _, _ or _ and the desired oven temperature. You may use the meat probe with
some other baking features but not be set with Broil or Flex=Clean.
9. During the cooking process you may check the actual internal temperature by pressing the @ key once. The
actual temperature will display. After 8 seconds the display will return to the actual oven temperature.
10. If the target temperature needs to be changed during the cooking process, press @ twice and use the numeric
keypads to adjust the target temperature. Press the _AR_ key to accept the change.
t The U.S. Department of Agriculture states, "Rare fresh beef is popular, butyou should know that cooking it to only 140°F/60°C
means some food poisoning organisms may survive." (Source: Safe Food Book, Your Kitchen Guide, USDA Rev. June 1985.)
The lowest temperature recommended by the USDA is 145°F/63°C for medium rare fresh beef.
Setting the oven to automatically stop cooking after reaching meat probe target temperature:
The oven leaves the factory preset to alert you when the internal target temperature has been reached but to continue
cooking at the oven set temperature. You may desire to change how your oven reacts when using the meat probe.
Note: Changing how the meat probe reacts must be done before starting the cooking process.
1. To set oven to shut-off automatically after reaching the Meat Probe target temperature press @ and hold for 7
seconds then use the @ key toggle to the message P CO (Probe, cancel cooking) then press (_ to accept.
2. Use the @ key to toggle back to PnOC (Probe, no cancel cooking) and then press _ to accept if you wish
for the oven to continue cooking after the meat probe reaches the target temperature.
19