Filter
Top Products
Self Cleaning
Self-Clean Cycle Time Length
Flex Delay
The cleo_pad controls the Self-Cleaning feature. When used with a the Startpad,
a delayed Self-Cleaning cycle may also be programmed. The Flex Clean feature
allows for any Self-Cleaning cycle time from 2 (2:00) to 4 hours (4:00). You may
also choose the clean time in 1 minute increments (for example 2 hours and 50
minutes) by pressing the number keypads 2 50.
If you are planning to use the oven directly after a self-clean cycle remember to
allow time for the oven to cool down and the oven door to unlock. This norma!ly
takes about one hour. So a 3 hour self-clean cycle will actually take about 4 hours
to complete.
_lt is recommend to use a 2 hour self-clean cycle for light soils, a 3 hour cycle for
average solls, and a 4 hour cycle for heavy solls (to assure satisfactory results).
To avoid possible burns
use care when opening the oven door
after the Self-Cleaning cycle. Stand
to the side of the oven when opening
the door to allow hot air or steam to
escape.
DO NOT force the
oven door open. This can damage
the automatic door locking system.
Use caution and avoid possible burns
when opening the door after the Self-
Cleaning cycle has completed. The
oven may still be VERY HOT.
INSTRUCTIONS PRESS DISPLAY
To start an immediate Self-Cleanlng cycle or to set a Delay
Start time of 9:00 o_clock and shut-off automatically (e×ample
provided is a default 3 hour Self-CJean cycle)
1. Be sure the clock is set with the correct time of day, the oven is
EMPTY and the oven door is closed.
Fbx
2. Press cl.... "CLEAN" will flash and "3:00" HR will show in the
display (Fig. 1). The control will automatically clean for a 3 hour
period (default self-cleaning cycle time). Note: If a 2 or 4 hour
clean time is desired, press 2 0 0 for 2 hour or press 4 0 0 for a
4 hour clean time. Set the cleaning time based on the amount of
soil: light, medium or heavy (_ See above).
3. Press _. The "DOOR LOCKED" icon will flash (Fig. 2).
4. The motor driven oven door loci< will begin to close automatically.
Once the door has been locked the "DOOR LOCKi_D" indicator
light will stop flashing and remain on (Fig. 3).
Note: Allow about 15 seconds for the oven door loci< to close.
Note: If the optlonal delay Self-Clean feature is needed, finish steps
5-7. If Self-Clean is started immediately sklp the remaining steps and
continue with "When the Self-Clean cycle is done" on the following
page.
Delay
5. Press Start(Fig. 4). Enter the desired Self-Clean starting time using
the number pads 9 0 0 (Fig. 5).
6. Press _T_. "DELAY", "DOOR LOCKED", "CLEAN" and Cooktop
locked icons will remain on.
7. The control will calculate forward from the set start time to
determine when the Self-Cleaning cycle should end. The Self-
Cleaning cycle will turn on automatically at the set time. At that
time the icon "DELAY" will go out; the oven icon wiii come on, the
start time, ';CLEAN" and "CLn" will remain in the display (Fig. 6)
Flex
Clean
2000r400
©
Delay
Start
900
@
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
28