Filter
Top Products
9
Oven Controls
Setting The Clock
When the appliance is first powered up, 12:00 will flash in the
display (Figure 3). The time of day must first be set before
operating the oven.
To set clock to 1:30:
1. Press .
2. Enter 1 3 0 using numeric keypad.
3. Press .
Important note:
The clock cannot be changed when a Cook Time, Self Clean,
Delay Start or cooking feature is active.
Setting Timer
The minute timer allows you to track your cooking times without
interfering with the cooking process. The timer may be set from
a minimum time of 1 minute to a maximum of 11 hours and 59
minutes.
To set timer for 5 minutes:
1. Press Timer Set-Off.
2. Enter 5 using numeric keypad.
3. Press to start timer. When set time ends, END will show
in the display and the control will sound a beep three times
every 30 seconds until Timer Set-Off key is pressed.
To cancel the timer when active press Timer Set-Off again.
Important note:
• The timer does not start or stop the cooking process. It
serves as an extra minute timer that will beep when the set
time has run out. The timer may be used alone or while
using any of the other oven functions.
• When timer is set for more than 1 hour it will display hours
and minutes until 1 hour remains. When less than 1 hour
remains, the display counts down in minutes and seconds.
With less than 1 minute remaining, only seconds will display.
• If the timer is active during a cooking process, the timer will
show in the display. To view the status of any other active
oven function, press the key of the cooking function once
and it will appear in the display for a few seconds.
Add 1 Minute
Use Add 1 Minute to set additional minutes to the timer. Each
press of the key will add 1 minute. If Add 1 Minute is pressed
when the timer is not active, the timer will activate and begin
counting down from 1 minute.
To add 2 minutes to the timer:
Press Add 1 Minute twice.
Setting 12 hour or 24 hour display mode
The clock display mode allows you to select 12 hr or 24 hr
modes. The factory pre-set clock display mode is 12 hours.
To set 12 hr or 24 hr display mode:
1. Press and hold for 6 seconds.
2. Press Self Clean to toggle between 12 Hr day or 24 Hr day
display modes. (Figure 4)
3. Press to accept choice.
Changing Between Continuous Bake Setting or 12 Hour
Energy Saving
The oven control has a factory preset built-in 12 Hour Energy
Saving feature that will turn off the oven if the oven is left on for
more than 12 hours. The control may be programmed to
override this feature to bake continuously.
To change between continuous bake or 12 Hour Energy Saving
feature:
1. Press and hold Timer Set-Off for 6 seconds
2. Press Self Clean to toggle between 12 Hour OFF or Stay On
(Figure 5) feature.
3. Press to accept choice
Figure 3: 12:00 in display before setting clock
Figure 4: 12 Hr dAy and 24 Hr dAy settings
Figure 5: 12 hr energy saving (L) and continuous setting (R)