Filter
Top Products
Self-Cleaning
To Start the Self=Clean Cycle
Flex
The FLEX CLEAN Cleonpad controis the Seif-Cieaning feature. If you are
planning to use the oven directly after a self-clean cycle remember to
allow time for the oven to cool down and the oven door to unlock. This
normally takes about one hour. So a 3 hour self-clean cycle will actually
take about 4 hours to complete.
*It is recommend to use a 2 hour self-clean cycle for light soils, a 3 hour
cycle for average soils, and a 4 hour cycle for heavy soils (to assure
satisfactory results)
INSTRUCTIONS
_J__ To avoid possible burns use
care when opening the oven door after the Self-
Cleaning cycle. Stand to the side of the oven
when opening the door to allow hot air or steam
to escape.
_DO NOT force the oven door
open. This can damage the automatic door locking
system. Use caution and avoid possible burns when
opening the door after the Self-Cleaning cycle has
completed. The oven may still be VERY HOT.
PRESS DISPLAY
To start an immediate Self=Cleanlng cycle or to set a Delay
Start time of 4:30 and shut-off automatically (example
provided is a default 3 hour Self=Clean Cycle)
1. Be sure the clock is set with the correct time of day and the oven
door is closed.
Lower
2. Press Oven.
Flex
3. Press cI.... "CLEAN" will flash and "3:00 HR" will show in the
display (Fig. 1). The control will automatically clean for a 3 hour
period (default self-cleaning cycle time). Note: If a 2 or 4 hour
clean time is desired, press 2 0 0 for 2 hour or press
4 0 0 for a 4 hour clean time. Set the cleaning time based on
the amount of soil: ligh h medium or heavy (* See above).
4. Press _. The "DOOR LOCKED" icon will flash; "CLEAN" icon
and the letters "CLn" will remain on in the display (Fig. 2).
5. As soon as the control is set, the motor driven oven door lock will
begin to close automatically. Once the door has been locked the
"DOOR LOCKED" indicator light will stop flashing and remain on.
Also, the oven icon will appear in the display (Fig. 3).
Note: Allow about 15 seconds for the oven door to lock.
Note: If the optional delay Self-Clean feature is desired, finish step
6-9. If Self-Clean is started immediately sklp the remaining steps
and continue with "When the Self-Clean cycle is done" on the
following page.
Delay
6. Press Sto_t(Fig. 4). Enter the desired start time using the number
pads 4 3 0 (Fig. 5).
Z Press _. "CLEAN", "DELAY", "LOCI(" and "DOOR" will be
displayed (Fig. 6).
9. The control wiii start the self-cleaning at the set start time, for the
period of time previously selected. At that time, the icon "DELAY"
wiii go out.
Lower
Oven
Flex
Clean
200or
4OO
@
Delay
Start
430
@
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
When the Self=Clean Cycle is Completed
1. "HOT" will appear in the display. The time of day, the "DOOR
LOCKED" and "CLEAN" icon wiii remain in the display.
2. Once the oven has cooled down for approximately 1 HOUR, and
the "DOOR LOCKED" icon is no longer displayed, the oven door
can then be opened.
31