Filter
Top Products
Before Setting Surface Controls
About the ceramic glass cooktop
The ceramic cooktop has radiant surface elements located
below the surface of the glass. The design of the ceramic
cooktop outlines the area of the surface element
underneath. Be sure to match the pan size with the
diameter of the element outline on the cooktop and only
flat-bottomed cool<ware should be used.
The type and size of cookware, the number of surface
elements in use and their settings are all factors that will
affect the amount of heat that will spread to areas beyond
the surface elements. The areas surrounding the elements
may become hot enough to cause burns.
About the radiant surface elements
The element temperature rises gradually and evenly. As the
temperature rises, the element will glow red. To maintain
the selected setting the element will cycle ON and OFF.
The heating element retains enough heat to provide a
uniform and consistent heat during the off cycle.
For efficient cooking, turn OFF the element several minutes
before cooking is complete. This will allow residual heat to
complete the cooking process.
Element On & Hot Surface indicator lights
Your appliance is equipped with two different types of
surface control indicator lights that will glow on the control
panel -- the ELEMENT ON indicator light and the Hot
Surface indicator lights (See Fig. 1).
The ELEMENT ON indicator light is marked on the control
panel and wiii glow when a surface element is turned ON.
A quick glance at this indicator light after cooking is an
easy check to be sure ALL surface controls are turned OFF.
The Hot Surface indicator lights are located on the control
panel just above each surface control knob. They will glow
when any surface cooking area heats up and will remain
on until the cooktop has cooled to a MODERATE level.
ELEMENT ON
Hot Surface _ O O
Radiant surface elements may appear to
have cooled after they have been turned off. The glass
surface may still be hot and burns may occur if the glass
surface is touched before it has cooled sufficiently.
Do not place plastic items such as salt and
pepper shakers, spoon holders or plastic wrappings on fop
of the range when if is in use. These items could melt or
ignite. Potholders, towels or wooden spoons could catch fire
if placed too close to the surface elements.
Do not allow alumlnum foil, empty glass/
porcelain cookware or ANY materlal that can melt to
make contact wlfh the ceramic cookfop. If these items melt
on the cooktop they may damage the ceramic cooktop.
Fig. 1
Important notes:
° Radiant elements have a iimiter that allows the radiant
heating element to cycle ON and OFF, even at the HI
setting. This helps to prevent damage to the ceramic
smoothtop. Cycling at the HI setting is normal and will
occur more often if the cool<ware is too small for the
radiant element or if the cookware bottom is not fiat.
° Be sure to read the detailed instructions for ceramic glass
cooktop maintenance and cleaning in the Care &
Cleaning and Before You Call checklist sections of this
Use & Care Guide.