Filter
Top Products
Setting Oven Controls
Setting the Clock
Changing between 12 or 24 hour display
Silent Control Operation
Setting the Clock
The CLOCK _ pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been
interrupted, the timer in the display will flash (See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
(_"). "CLO" will appear in the display (See Fig. 2).1. Press
,
Press (_(_)(_) pads to set the time of day to 1:30
(See Fig. 3). Press _. "CLO" will disappear and the clock
will start (See Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold _Q"_ for 6 seconds untill "12h" or "24h"
V
appears in the display.
2. Press _cc_,_ to switch between the 12 and 24 hour time of
day
v
display. "12h" or "24h" will be displayed (See Figs. 5 or 6).
3. Press (_ to accept the desired change or press O to
reject the change.
4. Reset the correct time as described in To set the clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 00:00 through 23:59 hours.
Setting Silent Control Operation
Fig. 1
PRESS
(_for 6 seconds
DISPLAY
Fig. 2
Fig. 3
i!ii: iiiiii!
!iiii:i
Fig. 4
Fig. 6
The DELAY START _and FLEX CLEAN (,,_ pads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to beoperated without sounds or beeps whenever necessary. If desired the control
can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
INSTRUCTIONS PRESS DISPLAY
To change control from normal sound to silent control operation:
1. To tell ifyour range isset for normal or silent operation press
and hold _s_tY_for 7 seconds.
(See Fig. 7)
2. Press _ to switch between normal sound operation and
v
silent operation mode. The display will show either "SP" (See
Fig. 8) or" =="(See Figs. 2 or 3).
for 7seconds
@
If "SP" appears (See Fig. 2), the control will operate with normal
sounds and beeps. If" - -" appears (See Fig. 9), the control is
set for silent operation mode.
3. Press @ to accept the change or press Q to reject the @orQ
change.
21
Fig. 7
Fig. 8
Fig. 9