Kenmore 790.99012 Oven User Manual


 
Setting the Clock
FEATURE OVERVIEW
Setting the Clock _M_DOw. ...............................
Changing between 12 or .......................
24 hour display
KI_HEN O_R MEA_P_ :,f_KES BREA_
TIMER LIGHT
Ot_VOFF OI_OFF FOODCATEGORIES
Setting the Clock
The CLOCK O pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply tothe range has been
interrupted, the timer in the display will flash with "PF" (power
failure, See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
1. Press 0" "CLO" will appear in the display (Fig. 2).
2,
Press _ _ _ pads to set the time of day to 1 _30
(Fig. 3). "CLO" wilt appear in the display. Press _.
"CLO" will disappear and the clock will start (Fig. 4).
PRESS
O
OQQ
Q
Figure 1
DISPLAY
Changing between 12 or 24 hour time of day display:
1. Press and hold O for 6 seconds (Fig. 3). While holding the
pad down the current time of day willremain and "CLO" will
disappear from the display (Fig. 4). CONTINUE holding the pad
until a beep is heard.
O for 6 seconds
2. The display will show either "12:00" (Fig. 5) or "24:00" (Fig. 6).
3. Press (_) to switch between the 12 and 24 hour time of day
display. The display will show either "12:00" (Fig. 5) or "24:00"
(Fig. 6).
4. Press _ to accept the change or press _ to reject the
change.
5. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
16
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6