Filter
Top Products
Filter Performance Data Sheet
Model Number 5231JA2006E
Use with replacement cartridge 5231JA2006E
This system has been tested according to NSF/ANSI 42 for the reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a
concentration less than equal to the permissible limit for water leaving the system, as specified in
NSF/ANSl 42.
System tested and certified by NSF International against NSF/ANSl Standard 42 for the
reduction of Chlorine, Taste and Odor and Nominal Particulate Class III.
Max.
Contaminant Average Influent Challenge Product Average % NSF Reduction Effluent Min. % NSF
concentration. Units Water Reduction Requirements Reduction Test
Reduction Influent apply to each row mg/L
Particulate
Class I Particle size: 5600000 At least 10 000 833333 93.2 _>85% 470000 91.6% 511032-03
>0.5 to <1 um particles/ml
Chlorine taste and odor 1.9 mg/L 2.0 mg/L + 10% 0.05 mg/L 97.4 ->50% 0.05 mg/L 97.4% 511031-03
To a capacity of 300 gallons (1.135 L).
* Note that while the testing was performed under standard labaratory conditions, actual performance may vary.
Application Guidelines / Water Supply Parameters
Water pressure 30 - 100 psi !207 - 689 kPa)
Water temperature 33°F - 100°F (0.6°C - 37.8°C)
Service flow 0.5 gpm (1.9 Ipm)
To reduce the risk associated with ingestion
of contaminants due to use with water that is
microbiologically unsafe or of unknown
quality.
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system.
Systems must be installed and operated in
accordance with manufacturer's recommended
procedures and guidelines.
[]CAUTION
To reduce the risk of property damage due to water leakage:
• Read and follow Use instructions before installation and use of
this system.
• Install on COLD water lines only.
• Company with all state and local plumbing codes.
Never install or operate where inlet water pressure may exceed
125 psi (862 kPa).
• Protect filter from freezing. Remove filter in temperatures
below 34°F (1°C).
• Replace cartridge at specified service interval. Cartridge
MUST be replaced at least every 6 months.
• After replacing the water filter cartridge, dispense 2.5 gallons
(9.46 liters) of water to purge the system, depressing and
releasing the dispenser pad in cycles of 30 seconds ON and
60 seconds OFF. Discard the purged water.
To purchase a replacement filter, visit your local Sears store or
call 1-800-4-MYHOME ®.Visit us on the web at www.sears.com
Product distributed in the United States
by Sears Brands Management Corporation,
Hoffman Estates, IL 60179
25