Kenmore 795.5137 Refrigerator User Manual


 
UNDERSTANDING SOUNDS YOU MAY
HEAR
Your new refrigerator may make sounds that your old
one did not make. Because the sounds are new to you,
you might be concerned about them. Most of the new
sounds are normal. Hard surfaces, like the floor, walls and
cabinets, can make the sounds seem louder than they
actually are. The following list describes the kinds of
sounds and what may be making them.
, The defrost timer will click when the automatic defrost
cycle begins and ends. The thermostat control (or
refrigerator control, depending on the model) will also
click when cycling on and off.
, Rattling noises may come from the flow of refrigerant,
the water line, or items stored on top of the refrigerator
, Your refrigerator is designed to run more efficiently to
keep your food items at the desired temperature.
The high efficiency compressor may cause your new
refrigerator to run longer than your old one, but it is still
more energy efficient than previous models. While
running you may hear a pulsating or high-pitched sound.
You may hear the evaporator fan motor circulating the air
through the refrigerator and freezer compartments.
As each cycle ends, you may hear a gurgling sound due
to the refrigerant flowing in your refrigerator.
Contraction and expansion of the inside walls may cause
a popping noise.
Water dripping on the defrost heater during a defrost
cycle may cause a sizzling sound.
You may hear air being forced over the condenser by the
condenser fan.
, You may hear water running into the drain pan during the
defrost cycle.
REFRIGERATOR DOES NOT OPERATE
Check if... Then...
The power supply cord is unplugged. Firmly plug the cord into a live outlet with proper voltage.
A household fuse has blown or circuit breaker tripped. Replace the fuse or reset the circuit breaker. Check that
the house circuit is not overloaded.
Refrigerator is in the defrost cycle.
Display shows the word OFF.
Wait about 30 minutes for defrost cycle to end.
The refrigerator control has been put into the store Demo
(Demonstration) Mode.
The Demo Mode disables the cooling system, but the
compartment lights continue to turn on and the control
panel also displays normally.
To disable Demo Mode open refrigerator door, then press
Ultra Ice and Fridge Temp buttons at the same time
for 5 seconds. When Demo Mode is deactivated, your
temperature settings will be displayed.
VIBRATION OR RATTLING NOISE
Check if...
i The refrigerator is not resting solidly on
the floor.
Then...
Floor is weak or uneven or leveling legs need adjusting, i
See DOOR ALIGNMENT Section.
I
LIGHTS DO NOT WORK
Check if... Then...
The power supply cord is unplugged. Firmly plug the cord into a live outlet with proper voltage.
LED light failure. Do not remove the LED light, it is only to be removed by
a qualified technician.
28