Filter
Top Products
Care & Cleaning
Raising and lowering the cooktop (some models)
To avoid possible burns DO NOT turn
the surface elements on when the cooktop is raised. Be
sure that the tap is completely lowered and securely in
place before turning on any of the surface burners.
When lowering the lift-up range coal<tap,
grasp the sides with fingertips only. Be careful not to
pinch fingers. Do not drop or bend the caoktop when
raising or lowering. This may permanently damage the
caaktap surface.
cooktop
\
!p rods
Replacing oven light (some models)
Be sure the range is unplugged and all parts
are COOL before replacing oven light. Wear a leather-
faced glove far protection against passibMe broken glass.
The oven light is located at the rear of the oven cavity and
is covered with a glass shield held by a wire holder. The
glass shield protects the light buMb and must be in place
whenever the oven is in use.
glass
shield
wire
holder
Fig. 1
To raise and lower the cooktop:
1. Remove all items from cooktop and set aside.
2. Grasp the sides of the caaktap and then lift from the
front (See Fig. 1).
3. Lift the coakop high enough to allow the support rods
to snap into place. The lift-up rods will support the
cooktop in the raised position.
4. If necessary, dean underneath using hot, soapy water
and a clean cloth; then dry.
5. To lower the cooktop, grasp the front corner of each
side of the top while pushing back on each rod with
the heel of your hand. This will release the notched
support. Hold the range cooktop and gently slide the
top back down [eve[ to the range.
To replace the interior oven light bulb:
1. Turn electrical power off at the main source or unplug
the range.
2. Press wire holder to one side to release the glass shield
that covers the light bulb.
3. Replace light with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder
back into place.
5. Turn power on at the main source (or plug the appliance
in).
6. The clock will then need to be reset. To reset, see
Setting clock in this Use & Care Guide.
Electrical outlet and circuit protection
(on some models)
For protection against surcharge, a 15 amp, 120 volt circuit
breaker reset is provided near the electric outlet located on
top of backguard panel. If needed, press circuit breaker
switch to reset. On some models a night light feature is
included. The night light switch will be located on the
backguard panel.
29