Filter
Top Products
Date: 12/28/07
Parts& RepaLrServices
SF22-804
Page 4 of 6
7. Install the resistor on the rear wall as
shown in the photo. Carefully punch or
drill a starter hole for the screw if
necessary.
8. Use existing screw holes to install the
new 120 ° thermostat to the left of the
existing 170 ° thermostat. Mark the
chassis with an "X "or "120" to identify
the new thermostat.
9. Install wire # 1 (318052584) onto the
"C" terminal of the new switch. This
wire has a push on terminal on one
end and is stripped on the other end.
10. Disconnect the power wire from the
170 ° thermostat, cut off the terminal
connector and strip approx. 3/16 inch
of the insulation. The power wire is
the one that does not connect to the
fan motor.
(318052584
From Kit
Confidential Information -For Internal Use Only
DEPARTMENT 702HSX - Leo Steinys
DEPARTMENT 702PSO - Bob Vondale