Filter
Top Products
b
efore using your Kenwood
appliance
●
R
ead these instructions carefully and
r
etain for future reference.
●
Remove all packaging and any labels
including the plastic blade covers
from the knife blade. Take care
the blades are very sharp.
These covers should be discarded
as they are to protect the blade
during manufacture and transit only.
safety
●
The blades are very sharp, handle
with care. Always hold by the
finger grip ቧ at the top, away
from the cutting edge, both
when handling and cleaning.
●
Switch off and unplug:
●●
before fitting or removing parts
●●
after use
●●
before cleaning.
●
Always wait for the blades to
completely stop before removing the
power unit from the bowl.
●
Always remove the knife blade(s)
before emptying or pouring contents
from the bowl.
●
Never use a damaged appliance.
Get it checked or repaired: see
‘service and customer care’.
●
Never let the power unit, cord or
plug get wet.
●
Don’t let excess cord hang over the
edge of a table or worktop or touch
hot surfaces.
●
Never leave the appliance on
unattended.
●
Misuse of your food chopper can
result in injury.
●
Never use an unauthorised
attachment.
●
T
his appliance is not intended for
use by persons (including children)
w
ith reduced physical, sensory or
m
ental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
●
Children should be supervised to
ensure that they do not play with the
appliance.
●
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before plugging in
●
Make sure your electricity supply is
the same as the one shown on the
underside of the appliance.
Important - UK only
●
The wires in the cord are coloured
as follows:
Blue = Neutral
Brown = Live.
●
The appliance must be protected by
a 3A approved (BS1362) fuse.
Note:
●
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
English
2