Filter
Top Products
know your Kenwood deep fryer
safety
●
Never plug in the fryer before filling the bowl with oil.
●
Keep children away during use and after - fat stays hot
for a long time.
●
Never let the cord touch hot surfaces or hang down
over the worktop edge - a child could grab it and pull
the fryer down. Place excess cord in cord storage area
at the back of the fryer.
●
Never touch the bowl, pour away oil or move your fryer
while the oil’s hot.
●
Never put the electrics unit in water. Remove it before
washing the rest of your fryer.
●
After cleaning, ensure the bowl and its electric pins are
dry before use.
●
Never leave your fryer on unattended.
●
Take care when removing the electrics unit - the
temperature probes may be hot.
●
Do not use if there is any damage to the fryer, cord or
plug. Get it checked or repaired: see ‘service’.
●
Only use the electrics unit supplied.
●
Watch out for steam during cooking and when you
open the lid.
●
Never put your fryer near or on cooker hot plates.
●
Always unplug the fryer after use.
●
This appliance is not intended to be operated by
means of an external timer or separate remote-control
system.
●
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure that they do
not play with the appliance.
●
Only use the appliance for its intended domestic use.
Kenwood will not accept any liability if the appliance is
subject to improper use, or failure to comply with these
instructions.
before plugging in
●
Make sure your electricity supply is the same as the
one shown on the underside of the electrics unit.
Important – UK only
●
T
he wires in the cord are coloured as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
●
The appliance must be protected by a 13A approved
(BS1362) fuse.
●
WARNING: THIS APPLIANCE MUST BE
EARTHED.
Note:
●
For non-rewireable plugs the fuse cover MUST be
refitted when replacing the fuse. If the fuse cover is lost
then the plug must not be used until a replacement can
be obtained. The correct fuse cover is identified by
colour and a replacement may be obtained from your
Kenwood Authorised Repairer (see Service).
●
If a non-rewireable plug is cut off it must be
DESTROYED IMMEDIATELY. An electric shock hazard
may arise if an unwanted non-rewireable pug is
inadvertently inserted into a 13A socket outlet.
●
This appliance conforms to EC directive 2004/108/EC
on Electromagnetic Compatibility and EC regulation no.
1935/2004 of 27/10/2004 on materials intended for
contact with food.
before using for the first time
1 Remove all packaging.
2 Dismantle: see ‘to dismantle, assemble and use your
fryer’.
3 Wash the parts: see ‘cleaning’.
know your Kenwood fryer
ቢ removable lid with permanent mesh filter
ባ viewing window
ቤ lid seal
ብ condensation trap
ቦ rise and fall control
ቧ pouring lips
ቨ removable bowl
ቩ lid release
ቪ carrying handles
ቫ electrics unit
ቭ timer
ቮ temperature control with neon light
ቯ temperature probes
ተ cord storage
2