Filter
Top Products
6
Figure 8
M
P
Box adjustment
The hood can be installed in cabinets with different depths (see
also figure 1 for details); however the front of the slider box must
always be flush with the front of the cabinet.
For alignment, adjust the back stops of the box.
For box adjustment, loosen screws M, slide the square plates
P as necessary, and tighten screws M (Figure 8).
Ensure that the drawer, when fully retracted, turns OFF all
power by acting positively on the rear microswitch.
Final installation steps
• Insert lamps in place.
• Fit the Lamp Shield.
• Fit the Grease Filters.
• Check all light bulbs to make sure they are secure in their
sockets, then turn power on in service panel and check lights
and blower operation per Use & Care section of this manual
and install filters.
• Make sure to leave this manual for the home owner.