Filter
Top Products
12
Hot Water/Rinse
Your Brewer is equipped to dispense hot
water to make hot chocolate, tea, soup,
and more. Your Brewer is also equipped
with a Rinse cycle to flush out residual
flavors. The Rinse cycle will dispense about
4 oz. of hot water.
Note: We suggest to running the Rinse
cycle before using hot water to flush out any
residual coffee, tea or hot cocoa flavor.
To Rinse:
1. Place a cup or mug on the drip tray.
If you’ve just completed a Rinse or Hot
Water cycle, proceed to step 4.
2. Lift the handle. The brewing chamber
will open towards you; check to make
sure there is no K-Cup
®
inserted.
3. Lower the handle to close the brewing
chamber. When closed completely, the
control panel will indicated READY.
4. Press Rinse. During the Rinse cycle, only
the Rinse button will be lit. The control
panel will display the word RINSE (see
figure 11).
Following the Rinse cycle, your Brewer
will automatically fill and heat in
preparation for the next cycle. Once the
heat cycle is completed, the RINSE and
HOT WATER buttons will remain lit for
one minute. While buttons are lit, you
can perform another Rinse cycle or
dispense Hot Water without opening the
brew chamber.
Note: To BREW directly after a Rinse
cycle open the brewing head, insert a
K-Cup and brew as normal.
To make Hot Water:
1. Place a cup or mug on the drip tray.
If you’ve just completed a Rinse or Hot
Water cycle proceed to step 4.
2. Lift the handle. The brewing chamber
will open towards you; check to make
sure there is no K-Cup
®
inserted.
3. Lower the handle to close the brewing
chamber. When closed completely, the
control panel will indicated READY.
4. All brew-size icons will be displayed with
your default size shown as a solid mug.
To choose a different size, use the
or
buttons.
5. Press Hot Water. While the Hot Water
cycle is in progress, only the Hot Water
button will be lit. The control panel will
display the words HOT WATER, as well
as the serving size you selected (see
figure 12).
Following the cycle, your Brewer will
automatically fill and heat in preparation
for the next cycle. After the heating
cycle is completed, you can perform a
Rinse or another Hot Water cycle
immediately for up to one minute. The
RINSE and HOT WATER buttons will be
lit. After this time the unit will return to
Idle mode and OPEN HEAD will be
displayed.
Note: To BREW directly after a Hot
Water cycle open the brewing head,
insert a K-Cup and brew as normal.
figure 12
figure 11