Automatic Door Lock
As soon as you program the oven for the self-cleaning
function, the door will automatically lock. It will remain
locked throughout the entire cycle. The door will
automatically unlock when the temperature lowers to a
safe level.
Important: After self cleaning the oven, the oven
selector knob must be left in the clean position until the
oven has cooled down and the door has unlocked. If you
have turned the selector off prior to the door unlocking,
turn the selector and control to “Clean”. The door will
unlock. You can then turn the selector to “Off”.
MAINTENANCE & MINOR REPAIR
Removable Oven Door
The oven door is removable to allow easier manual cleaning
inside the oven if desired.
Removing the Oven Door:
Completely open oven door. In both back corners of the
door you will see door latches in the locked position.
Rotate both latches forward to the unlocked position.
Grasp outside edges of door with both hands.
• Begin closing door, at the moment the door stops
closing, lift and pull door toward you.
• Set door aside on a protective surface.
Resetting Breakers
In case of a stove malfunction, try resetting the breaker, at
the main breaker panel.
Clock Malfunction
If you have experienced a power surge or loss of power
recently, your clock may have “locked up”. Turn power
off to your range for about 15 seconds then reconnect.
This should reset clock/control and it should now function
normally.
REPLACING OVEN LIGHTS
To Replace Oven Light on Model 1956:
1. Unplug appliance or disconnect at the mail power
supply.
2. Replace the oven lights with a #4452166 15W
appliance bulb. These bulbs are available from a
Whirlpool/KitchenAid dealer or from Elmira Stove
Works.
3. All cabinet lights are the rectangular 12 volt 5 watt
variety as shown below.
To Replace Oven Lights on all Models but
1956:
Lights on the range are 12-volt, 5-watt (maximum)
halogen bulbs.
Before replacing, make sure the oven is off and cool
1. Disconnect power.
2. Remove glass light cover by grasping the front edge
and pulling away from oven.
3. Remove bulb from socket. Do not touch bulb with
fingers.
4. Replace bulb, replace bulb cover by snapping back
into wall.
5. Reconnect power.
16