Filter
Top Products
Product dimensions
/+-3V (762cm) width -W
height
Cabinet dimensions
30” (76.2cm) min. base cabinet is required.
If cabinet has a drawer, a 3” (75cm) depth
clearance from the countertop to the top of
the drawer (or other obstruction) in the base
cabinet is required.
30” (76.2cm) min. cabinet
h-width above cooktop
16” (45.7cm)
f
For minimum
clearances,
see Note.*
I
13Lk+
4,
max. upper
cabinet
countertop.
25” (63.5cm)
countertop
depth
24” (61cm)
lower cabmet
depth
(30cm) or
more above
the floor
line.
min.
Note: 24” (61cm) min.
clearance rf bottom of
wood or metal cabinet is
protected by not less than
l/4” (O&m) flame
‘/
retardant millboard
covered with not less than
/
No. 28 MSG sheet steel,
0.015” (0.04cm) stainless
steel, or 0.024”(0.06cm)
’ aluminum or 0.020”
(OJXcm) copper.
30” (76.2cm) min.
clearance between top of
cooking platform and
bottom of unprotected
wood or metal cabinet.
Cutout dimensions
-Minimum
distance
to nearest left side
and rear combustible
surface
above
countertop
Before you start...
Proper installation is your responsibility.
Make sure you have everything for correct
installation. It is the responsibility of the
installer to comply with the installation
clearances specified on the serial/rating
plate. The serial/rating plate is found on the
bottom of the cooktop.
Cooktop installed over oven installation:
Cooktop models KECC500W, KECC500B,
YKECC500B and YKECC500W can be
installed over oven models KEBNl OOY,
KEBNlO7B and RB262PXA.
Check location where cooktop will be
installed. The location should be away from
strong draft areas, such as windows, doors
and strong heating vents or fans. The
cooktop should be located for convenient
use in the kitchen.
Important:
Observe all governing codes and
ordinances.
Failure to meet governing codes and
ordinances could lead to fire or electrical
shock.
Countertop opening dimensions that are
shown must be used. Given dimensions are
minimum clearances and provide required
0” (Ocm) clearance.
New installations -follow minimum
dimensions given.
Replacement installations - Be sure that
front edge of cooktop is at least l-1/2”
(3.8cm) back from front edge of countertop.
A built-under oven may be installed under
this cooktop if oven is approved for this type
of installation. Check for approval label
located on top of oven. If label is not
located, contact dealer to confirm that oven
is approved. Refer to oven manufacturers
Installation Instructions for approval and
proper cutout dimensions.
When installing cooktop over a built-
under oven, Do Not fasten cooktop to
countertop with clamps. Cooktop then will
be easy to remove if servicing is ever
necessary.
ALL OPENINGS IN THE WALL OR FLOOR
WHERE THE COOKTOP IS TO BE
INSTALLED MUST BE SEALED.
Electrical Shock Hazard
It is the customer’s responsibility:
l To contact a qualified electrical
installer.
l To assure that the electrical
installation is adequate and in
conformance with National Electrical
Code, ANSVNFPA 70 - latest
edition**,
or Canadian Electrical
Code, C22.1 - 1982 and C22.2 No.
01982 (or latest edition)*‘* and all
local codes and ordinances.
Failure to do so could result in
electrical shock or other personal
injury.
Personal Injury Hazard
Cabinet storage above the cooking
surface should be avoided. If cabinets
are already installed, reduce the
hazard of reaching over a heated
cooking surface by installing a range
hood.
The range hood should extend a
minimum of 5 inches out from the
bottom of the cabinets.
Reaching over a heated cooking
surface could result in a serious burn.
Copies of the standards listed may be
obtained from:
**National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
***Canadian Standard Association
178 Rexdale Boulevard
Rexdale, (Toronto ), Ontario M9W 1 R3
Panel A