KitchenAid 4171206 Dishwasher User Manual


 
(17
- I
Place level against
. interior flange as shown.
Level dishwasher front to back and
side to side by adjusting leveling
close easily without slamming and
should not open with its own weight.
If necessary, close door and adjust
door spring bracket. If the door
closes too fast from an open
position, adjust the door spring
brackets upward to a different hole.
If door falls open too quickly, move
spring bracket downward.
Electrical Shock Hazard
Disconnect power before
making electrical connection.
Failure to do so could result In
electrical shock.
B-l
Remove terminal box
. cover. Install conduit
connector to box. Insert power
cable through grommet. Connect the
white wire of the power supply cable
to the white leads in the terminal box
with twist-on wire connectors.
Connect the black wire of the power
supply cable to the black leads in
the terminal box with twist-on wire
connectors.
Connect the grounding wire of the
power supply cable to the grounding
screw on the dishwasher frame.
Replace terminal box cover.
120
Remove all shipping
n
materials. Do Not
remove the white plastic plug
buttons from the side of door or the
plastic bumpers from the front
corners of the lower rack. Do Not
remove the two spring retainers
attached to the heater (not included
on all models).
1211
Take a few minutes to
read the Use and Care
Guide to fully understand your new
dishwasher.
122
Check that all parts have
. been installed and no
steps were skipped. Check that you
have all the tools you started with.
123
CHECK ELECTRICAL
REQUIREMENTS. BE
SURE YOU HAVE CORRECT
ELECTRICAL SUPPLY AND
RECOMMENDED GROUNDING
METHOD. Turn on electrical
supply. Turn on the water supply.
124
Start dishwasher and
. allow it to complete a
cycle. Check that dishwasher is
working properly and that there are
no water leaks. I
II
access
125
Replace toe panel with
g two screws. Check that
the opening at the bottom of toe
panel is clear so air can circulate to
cool the motor. Align access panel
flanges to fit under channel. Slide
panel up until it stops. Push up tabs
located at bottom of access panel
until tabs hook over frame. Use two
screws to attach panel.
126
If color of door is to be
n
changed or custom panel
installed, change the panel now.
See Use and Care Guide for
instructions.
To get the most efficient use from
your new dishwasher, read your
KitchenAid Use and Care Guide.
Keep Installation Instructions and
Guide close to dishwasher for
easy reference.
Page 7