Filter
Top Products
Custom-made
panels
-23 9116"
I----
-I
*For Models: KUDA220T and
KUDA22ST-17-7/16”
Custom wood or other materials
should be l/4” thick. Thinner
materials will need to have a spacer
panel installed behind custom
panel.
If custom panel is more than
i/4” thick, the outer edge
will need to be routed as shown.
Custom wood panels need a
waterproof protective finish applied
to all sides and edges of panel.
After custom panels are installed,
check the door tension. The door
should be counterbalanced so it
doesn’t fall open or close when
opened. If the door closes from an
open position, adjust the door-spring
brackets upward to a different hole.
If door falls open too quickly, move
spring bracket downward. If custom
panels are heavy, heavy-duty door
springs are available from your
KitchenAid dealer.
If the dishwasher
is not operating
properly.. .
Check these points:
l
Is the door closed tightly and
latched securely?
9 Has the cycle been set correctly
to start the dishwasher?
l
Is the water turned on?
l
Has a house fuse blown?
l
Has electrical power been
interrupted?
Note: If the motor has stopped
because of overload, it will
automatically reset itself within a
few minutes.
If after checking these points the
dishwasher still does not run or
complete a cycle, call for service.
Part No. 4171206
01989 KitchenAid
Prepared by KitchenAid@, St. Joseph, Michigan 49085
Printed in U.S.A.