Filter
Top Products
English
11
To Attach Pouring Shield
1. Turn speed control to “O”.
2. Unplug Stand Mixer or disconnect power.
3. Attach flat beater, dough hook, or wire
whip and bowl (see page 8 for
tilt-head models, see page 10 for
bowl-lift models).
4. From the front of the Stand Mixer, slide
the pouring shield over the bowl until the
shield is centered. The bottom rim of the
shield should fit within the bowl.
To Remove Pouring Shield
1. Turn speed control to “O”.
2. Unplug Stand Mixer or disconnect power.
3. Lift the front of the pour shield clear of
the bowl rim and pull forward.
4. Remove accessory and bowl.
To Use Pouring Shield
1. For best results, rotate the shield so the
motor head covers the “u” shaped gap
in the shield. The pouring chute will be
just to the right of the accessory hub
as you face the Stand Mixer.
2. Pour the ingredients into the bowl
through the pouring chute.
Assembling Your Pouring Shield*
* If Pouring Shield is included.
Pouring Chute
Assembling Your Bowl-Lift Mixer
To Remove Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Lower bowl by rotating bowl-lift
handle downward.
4. Press beater upward and turn right.
5. Pull beater from beater shaft.
Stand Mixer Speed Control
To reduce the potential for splash-out,
always begin mixing using Speed 1 (STIR
speed), then gradually move to higher
speeds as needed. See page 14 for “Speed
Control Guide.”
Auto-Reset Motor Protection
If the Stand Mixer stops due to overload,
slide the speed control lever to “O”.
After a few minutes, the Stand Mixer will
automatically reset. Slide the speed control
lever to the desired speed and continue
mixing.
If the unit does not restart, see “When
You Need Service” on page 19.
Pin
10
21
4
6
8
O