Filter
Top Products
English
19
To Remove
1. Turn speed control to “O”.
2. Unplug Stand Mixer or
disconnect power.
3. Loosen accessory knob by turning it
counterclockwise. Rotate accessory
slightly back and forth while
pulling out.
4. Replace accessory hub cover. Tighten
accessory knob by turning it clockwise.
Please read the following before
calling your service center.
1. The Stand Mixer may warm up during
use. Under heavy loads with extended
mixing time periods, you may not be
able to comfortably touch the top of
the unit. This is normal.
2. The Stand Mixer may emit a pungent
odor, especially when new. This is
common with electric motors.
3. If the flat beater hits the bowl, stop
the Stand Mixer. See “Beater to Bowl
Clearance,” page 12.
If your Stand Mixer should malfunction
or fail to operate, please check the
following:
- Is the Stand Mixer plugged in?
- Is the fuse in the circuit to the Stand
Mixer in working order? If you have a
circuit breaker box, be sure the circuit is
closed.
- Turn the Stand Mixer off for 10-15
seconds, then turn it back on. If the
Stand Mixer still does not start, allow it
to cool for 30 minutes before turning it
back on.
- If the problem is not due to one of the
above items, see “Service Centers.”
When You Need Service
General Instructions