Filter
Top Products
9
Changing the
Decorative Panel
23
13
⁄16
"
(60.5 cm)
14
5
⁄8"
(37.2 cm)
Raised panel: The outer section of panel must be
7
⁄32"
(5.6 mm) thick to fit into trim. Raised panel dimensions as
shown above.
Custom-made panel dimensions
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate
clearance may be changed as follows:
1. Mark on each side of the toe plate the amount of toe
plate that rubs the floor covering.
2. Remove the drawer from the unit. (See step 3 in the
“Unpacking Your Compactor” section.)
3. Use a ruler and a pencil or chalk to draw a line
between the marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering,
repeat steps 1-4.
Flat panel: A
7
⁄32" (5.6 mm) thick panel is required. This is
the same thickness as a standard
1
⁄4" plywood or paneling.
Trim for decorative panel
Order trim for installation of a custom-made panel through
your KitchenAid dealer or by calling the KitchenAid
Consumer Assistance Center at 1-800-422-1230. In
Canada, call 1-800-807-6777.
Trim for custom-made panels available are:
Part No. 9871381 (Brushed stainless steel)
Part No. 9871382 (White)
Part No. 9871383 (Black)
Part No. 9871384 (Almond)
Part No. 9871600 (Biscuit)
7
⁄32"
(5.6 mm)
1
1
⁄4"
(32 mm)
5
⁄16"
(8 mm)
both sides
5
⁄16"
(8 mm)
outer section
of panel
raised
panel or
decorative
trim
14
5
⁄8"
(37.2 cm)
23
13
⁄16"
(60.5 cm)