Filter
Top Products
English
11
OPERATING THE COFFEE BREWEROPERATING THE COFFEE BREWER
3
After pressing SET to choose AM or PM
for your Delay start brew time, 2 beeps
will sound and you will be returned to
the programming menu. The Delay start
program is ready to use.
The water tank holds between 2 and 8 cups
of water (5 oz. each) for brewing. Since you
are able to select the number of cups you’d
like to brew each time, you do not have to
fill the water tank with the exact amount of
water you need. The Coffee Maker will use
the correct amount of water for the number
of cups you select.
Filling the water tank
1
Slide the water tank lid back, and fill
the water tank with fresh, filtered water
to the desired cup level as indicated on
the water tank view. Because of the
design of this Coffee Brewer, it may take
a moment for the water to enter the
place in the tank where you can view the
water level. Close the water tank lid.
You can use the same Delay start brew time
again by pressing the menu button twice, then
pressing SET three times before brewing. To
cancel the Delay start feature at any time,
press the BREW button two times.
NOTE: You must complete step 4 each time you wish to enable the Delay start feature.
NOTE: If the water in the tank has been sitting for awhile and you wish to start fresh,
select 8 cups and press the BREW button (without coffee in the brew basket). This will
cycle through any stale water in the tank.
HELPFUL TIP: For best taste and brewing results, make sure you have enough water in
the tank for the number of cups you want to brew.
W10661890A_EN_Final2.indd 11 7/2/14 9:48 AM