Filter
Top Products
0
3 DRAIN SYSTEM (Cont.)
--‘-
34’
-
u-------y
-!
I
MIX.
(57*~01R0)
MIX.
(57*~01R0)
---00”
-00” MAX. IN RESRICIED - -
MAX. IN RESRICIED - -
CODC AREA) CODf AREA)
i
P-IK)t,
t-u
m
--
FIG. 5
NOTE: Drain Hose #B-240385 may be used
to connect dishwasher with disposer unit, or
to sink drain using Tee P-83095 or elbow
M-66693 (available as accessories).
CAUTION: Make sure drain hose does not
touch any electrical components or terminaF
Drain hose must withstand hot water and
detergent and can be obtained from a plumb
ing hardware or automotive supply outlet.
Other accessories available from your
dealer or distributor are:
Top Kits
Rinse Agent Kit
Front Trim Kit
Side Panel Kits Front Panel Kits
0.
4
ELECTRICAL SUPPLY LINE
Before setting dishwasher in place, run
individual 15 amp. minimum branch circuit
with grounded electrical cable. (A, Fig. 6)
shows routing methods for the electrical
supply line hook-up to the KitchenAid
dishwasher. CAUTION: No other outlets or
appliances should be on this circuit
JUNCIION DOX
FIG. 6
FINAL INSTALLATION
0
1 POSITIONING AND R
emove Styrofoam packing blocks and
corrugated motor block packing after
A NC H 0 RI N G
dishwasher is removed from skid. Re-
DISHWASHER
move protector panel before front
panels are installed. Check the upper
DOOR
SPRING BRACKET
FIG. 7
rear portion of the cabinet opening to make certain that area is
cleared of cabinet or top support framing members. Set the
dishwasher adjacent to cabinet and adjust the four leveling feet to
the desired height. The four leveling feet can be used to raise the
dishwasher to 36” or lower to X3-11/16” (33-7/16” if leveling
screws are removed). Adjust kickplate. Kickplate can be adjusted by
moving up or down.
After the dishwasher is in position, make sure it is level from side to
side and front to rear. If possible dishwasher front should be
parallel to counter top and flush with cabinets. To maintain
alignment of dishwasher with adjacent cabinets, fasten dishwasher
to counter top with two #lO flat head wood screws (not furnished).
Use these screws in the two L shaped adjustable brackets
(furnished) at the upper left and right hand corners of
T
,
dishwasher, When dishwasher is not installed beneath a continuou,.
counter top it may be necessary to anchor dishwasher to floor using
l/4” lag bolt or screw, in hole provided. If door tension adjustment
is required, adjust door spring so the door is counterbalanced and
will remain in open position. Adjust tension by changing bracket to
alternate holes and/or moving spring hooks to alternate position.