Filter
Top Products
7
Ton e s
Tones are audible signals, indicating the following:
One tone
■ Valid pad press
■ Oven is preheated
■ Function has been entered
Three tones
■ Invalid pad press
Four tones
■ End-of-cycle
■ Reminder, repeating each minute after the end-of-cycle tones
Tone Volume
The volume is preset at high, but can be changed to low.
To Change:
Press and hold the number pad “7” for 5 seconds. A
tone will sound and “Snd Lo” will appear on the oven display for
3 seconds. Repeat to change back to “Snd Hi”.
All Tones (double oven models)
All of the above tones are preset on, but can be turned off.
To Turn Off/On:
Press and hold STOP TIME for 5 seconds. A
tone will sound and “Snd OFF” will appear on the oven display
for 3 seconds. Repeat to change back to “Snd On”.
Pad Press Tones (single oven models)
The single tones signaling a valid pad press are preset on, but
can be turned off.
To Turn Off/On:
Press and hold STOP TIME for 5 seconds. A
tone will sound and “Snd oFF” will appear on the oven display for
3 seconds. Repeat to change back to “Snd on”.
End-of-Cycle and Reminder Tones
The Timer and Timed Cooking end-of-cycle and reminder tones
are preset on, but can be turned off. However, on double oven
models, if all tones have been turned off, the end-of-cycle and
reminder tones cannot be independently turned on.
To Turn Tones Off/On:
Press and hold COOK TIME until a tone
sounds and "EOC OFF" appears on the display. Repeat to turn
back on. "EOC On" will appear on the display.
Reminder Tones Only
The Timer and Timed Cooking reminder tones are preset on, but
can be turned off. However, on double oven models, if all tones
have been turned off, the reminder tones cannot be
independently turned on.
To Turn Tones Off/On:
Press and hold TIMER SET · START until
a tone sounds and "nAg OFF" appears on the display. Repeat to
turn back on. "nAg On" will appear on the display.
Fahrenheit and Celsius
The temperature is preset in Fahrenheit, however it can be
changed to Celsius.
To Change:
Press and hold BROIL · MAXI · · ECONO for 5
seconds. A tone will sound and “C” will appear on the display for
3 seconds. Repeat to change back to Fahrenheit. "F" will appear
on the display for 3 seconds.
When in Fahrenheit, “°F” follows the oven temperature.
When in Celsius, only “°” follows the oven temperature.
Timer
The Timer can be set in minutes and seconds or hours and
minutes and counts down the set time. It does not start or stop
the oven.
To Set:
1.
Press TIMER SET · START.
Press again to switch between MIN/SEC and HR/MIN.
If no action is taken after one minute, the display will return to
the time of day mode.
2.
Press the number pads to set the length of time.
3.
Press TIMER SET · START or START.
If not pressed within 5 seconds, the display will return to the
time of day mode and the programmed function will be
cancelled.
When the set time ends, "END" will appear in the display and
if enabled, end-of-cycle tones will sound, then reminder
tones will sound every minute.
4.
Press TIMER CANCEL anytime to cancel the Timer or stop
the reminder tones.
*Remember, if a Cancel Off pad is pressed, the respective
oven will turn off.
The time can be reset during countdown by repeating the
above steps.
Control Lock
The Control Lock shuts down the control panel pads to prevent
unintended use of the oven(s). The Control Lock will remain set
after a power failure if set before the power failure.
When the control is locked, only the CLOCK SET · START, TIMER
SET · START, TIMER CANCEL and OVEN LIGHT pads will
function. On single oven models, CANCEL OFF will also function
if pressed for one second.
Before locking, make sure the oven(s), Timer, Timed Cooking and
Sabbath Mode are off. On double oven models, the Control Lock
can be set if the oven(s) are on. The oven(s) will automatically turn
off. Press a Cancel/Off pad to clear the display.
The Control Lock is preset unlocked, but can be locked.
To Lock/Unlock Control:
Press and hold the number pad 3
CONTROL LOCK until “CONTROL LOCK” and a picture of a lock
appear on the display after about 3 seconds. Repeat to unlock
and remove “CONTROL LOCK” from the display.