Filter
Top Products
25
4.
Turn the tube 90° in either direction until both ends come out
of the receptacles.
5.
Replace tube, replace top of the control panel.
6.
Plug in range or reconnect power.
To Replace Starter:
1.
Unplug range or disconnect power.
2.
Remove tube.
3.
Push starter in and turn approximately 90° counterclockwise.
4.
Pull starter out of recessed area.
5.
Replace starter, tube and top of control panel.
6.
Plug in range or reconnect power.
Resetting Range Circuit Breakers
(on Canadian models only)
The breakers on the range are located under the fluorescent tube
and parallel to the starter. The breakers are for outlet protection.
To reset, push button on top of breakers.
Oven Light(s)
The oven light(s) is a 40-watt appliance bulb. The light(s) will come
on when the oven door is opened. The light(s) will not work during
the Self-Cleaning cycle. When the oven door is closed, press
OVEN LIGHT to turn the light(s) on or off.
To Replace:
Before replacing, make sure the oven is off and cool.
1.
Unplug range or disconnect power.
2.
Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3.
Turn bulb counterclockwise to remove from socket.
4.
Replace bulb and bulb cover by turning clockwise.
5.
Plug in range or reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1.
Fully open the oven door.
2.
Unscrew clips with a #2 square or Phillips screwdriver.
3.
Close oven door to the stop position (open about 4 in.
[10 cm]).
4.
Lift door slightly and pull out and back until hinges come out
to the catch position.
5.
Push door down and pull straight out to remove door
completely.
To Replace:
1.
Hold oven door by the handle and place the top of the door
under the cooktop overhang.
2.
Use front of leg to apply pressure to slide hinges into the slots
as far as possible.
3.
Use side of leg to apply pressure to the bottom of the door
front.
4.
Lift door slightly. Apply pressure and push until the hinges
have gone in fully.
5.
Fully open the door.
6.
Tighten clips with a #2 square or Phillips screwdriver.
Storage Drawer
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1.
Pull drawer straight out to the first stop.
2.
Lift up the back of the drawer and pull out.
To Replace:
1.
Fit the ends of the drawer rails into the guides in the cavity.
2.
Slide the drawer closed.
4"
4" (10 cm)